In the FTTX network, which of the following principles is wrong when planning data for broadband services?
A. The network management should use QinQ VLAN
B. If the outer labels of different PON ports are different, the inner labels can be the same
C. The same PON port is marked with different outer labels for different services
D. If the outer labels of different PON ports are the same, the inner labels cannot be the same
正解:A
質問 2:
When OLT traffic is scheduled, which of the following traffic will be marked as green?
A. Flow rate above CBS
B. Flow rate below CIR
C. Flow rate above PIR
D. Flow rate above CIR but below PIR
正解:B
質問 3:
Which of the following command is used to stop multicast emulation?
A. igmp static-join service-port x delete
B. undo igmp simulate service-port x
C. undo igmp static-join service-port x
D. igmp simulate service-port x delete
正解:C
質問 4:
When using NCE-FAN to configure FTTH TPTV service, which template will be used?
A. Value-added business template
B. IGMP Template
C. MGC Template
D. SNMP Template
正解:B
質問 5:
Deploying Ethernet port protection groups in the upstream direction of the OLT can improve uplink reliability and uplink bandwidth.
A. False
B. True
正解:A
質問 6:
Under the EH.248 protocol, if the signaling IP and media IP are both 10.1.1.100/8, and the voice gateway is 10.1.1.1, when configuring the volP service, which of the following command is wrong?
A. Use the command ip address media 10.1.1.100 10.1.1.1 to configure the media IP in voip mode
B. Use the reset cold start command under the voice interface to make the interface attribute configuration effective
C. Use the if-h248 attribute command to configure interface attributes under the voice interface
D. Use the command ip address signaling 10.1.1.100 10.1.1.1 to configure the signaling IP in voip mode
正解:D
質問 7:
The traditional fusion splicing scheme of POL ODN has centralized light splitting, heavy fiber baking workload and low construction efficiency.
A. TRUE
B. FALSE
正解:A
質問 8:
The automatic discovery methods provided by sight include network segment method, ARP method and routing method. At the same time, it supports the creation of the network segment or IP address of the device that does not need to be connected as an exclusion list. The network segment or IP address configured in the exclusion list is automatically skipped during the self-discovery process.
A. False
B. Ture
正解:B
绀野** -
私はH35-211_V2.5-ENU問題集と合わせて購入して、最近にH35-211_V2.5-ENUしけんに合格できました。
試験前もずっと勉強していたので、よかったです。Pass4Test参考書とあとは努力ですね。