Click the Exhibit button.

Servers in your environment are connected to one physical infrastructure which consists of different logical fabrics. Which feature do you use to implement this topology?
A. Zoning
B. NPIV
C. Virtual Fabric
D. Segmentation
正解:C
質問 2:
You have recently upgraded a tape drive on a older switch to operate at 120MB/s from 80MB/s. Prior to purchasing the tape drives, you tested server dumps to a disk array across multiple ports and saw speeds exceeding 150MB/s. With the new tape drive, you have not seen any dump speed exceed 100MB/s. What is the most likely cause?
A. You have not yet reset the switch port buffer credits.
B. The switch only has 1Gb/s ports.
C. The new tape drive has logged into the fabric as a storage initiator.
D. The tape drive has logged in as an iSCSI device.
正解:B
質問 3:
Which portion of the 24-bit (aabbcc) fiber channel address identifies the area?
A. aabb
B. cc
C. bb
D. bbcc
正解:C
質問 4:
A production cluster is attached to redundant disk fabrics and a tape fabric. Each cluster member has access to twelve (12) TB of RAID 5 production storage and twelve (12) TB of RAID 0 local replica accessed through eight HBAs single initiator zoned to sixteen storage ports on one storage subsystem. The tape fabric includes one connection to each server and connections to four (4) 1Gb FC to SCSI gateways connected to ten (10) LTO II (35MB/s) tape drives. The standby cluster member performs multi-threaded backups using the local replica. All HBAs and ports are 2Gb/s. If the recovery time is equal to backup time, where is the bottleneck?
A. FC to SCSI Gateway
B. Tape HBA
C. Tape Drives
D. Disk HBAs
正解:B
質問 5:
An application administrator seeks to improve the I/O performance of the server's SAN-attached storage. Which HBA parameter setting change can affect the performance?
A. Queue Depth
B. NL-Port Mode
C. SCSI ID Mapping
D. PCI Connection Type
正解:A
質問 6:
What function of SATA is the equivalent of SCSI command tag queuing?
A. SATA command queuing
B. native command queuing
C. native command tag queuing
D. SATA command tag queuing
正解:B
質問 7:
Click the Exhibit button.
You are troubleshooting an issue with Host 1 that should see newly installed storage devices A and B, however can only see Storage A and not Storage B.
Which two (2) items should you check? (Choose two.)
A. if Storage A is logged into the switch
B. if Host 1 is zoned to Storage B
C. if Host 1 is logged into the switch
D. if Storage B is logged into the switch
E. connectivity of the ISL between the two switches
正解:B,D
Mizuhara -
解答があるのは非常に良い。解説もまとまってる。過去問でどのくらいの結果が出るか楽しみです。