A BGP session shows the state as active.
What does the state indicate in this scenario?
A. The BGP session is fully established and routes are being passed.
B. A keepalive message has been received.
C. The TCP connection is successful, and BGP is waiting for the OPEN message from its peer.
D. The routes are still trying to establish a TCP connection.
正解:D
質問 2:
You are asked to configure filter-based forwarding (FBF) to forward traffic sourced from a specific subnet to a webserver.
In this scenario, which mechanism is used to add interface routes to the forwarding routing instance used in FBF?
A. RIB groups
B. forwarding policy
C. routing policy
D. generated routes
正解:A
質問 3:
Which three statements describe what happens when processing a frame for a switched packet? (Choose three.)
A. The egress PFE forwards the packet out the egress port towards the destination.
B. The ingress PFE sends the header information to the Routing Engine.
C. The ingress PFE performs the MAC address lookup.
D. The frame enters the ingress port and is processed by the ingress PFE.
E. The frame enters the ingress port and is forwarded out all ports.
正解:A,C,D
質問 4:
Click the Exhibit button.
Referring to the exhibit, which type of route is displayed?
A. aggregate
B. generate
C. static
D. martian
正解:B
質問 5:
Click the Exhibit button.
Referring to the exhibit, which router will be selected as the DR?
A. R5
B. R1
C. R3
D. R4
正解:C
質問 6:
Click the Exhibit button.
You are trying to form an IS-IS adjacency between Router A and Router B, but the IS-IS adjacency will not form between the two routers.
Referring to the exhibit, which action would solve this problem?
A. Enable level 2 IS-IS routing on Router B.
B. Enable level 1 IS-IS routing on Router A.
C. Enable IS-IS wide metrics on Router B.
D. Enable IS-IS wide metrics on Router A.
正解:A
質問 7:
Click the Exhibit button.
You are implementing the network shown in the exhibit. You must ensure that all users can communicate with each other.
What are three steps that should be taken in this scenario? (Choose three.)
A. You must create a unique logical IRB interface for each network and assign an IP address within the appropriate network.
B. You must specify the appropriate Layer 3 IRB interface under each VLAN.
C. You must define all ports as access ports and include the appropriate VLAN as a member.
D. You must configure a single logical IRB interface with an IP address for each of the three networks.
E. You must define all ports as trunk ports and include all VLANs as members.
正解:A,B,C
質問 8:
Click the Exhibit button.
You have created a GRE tunnel as shown in the exhibit. The router with tunnel endpoint A is dropping the packets originating from User A and destined to User B.
What would cause this problem?
A. Endpoint A is missing a policy statement that allows User A's traffic into the tunnel.
B. User A requested fragmentation and Endpoint A has the clear-dont-fragment-bit parameter enabled.
C. User A is sending maximum size default Ethernet frames with the DF bit enabled.
D. Endpoint A has the internet-options gre-path-mtu-discovery parameter enabled.
正解:C
Hashino -
JN0-349の試験に受かりました!!Pass4Test本当に有難うございます!