In which three scenarios is it possible to disable and remove the aggregate Snapshot copy? (Choose three.)
A. You are protecting volumes using SnapMirror XDP.
B. You are protecting the aggregate with RAID-DP.
C. You are protecting volumes using SnapMirror DP.
D. You are protecting the aggregate using SyncMirror.
E. Your cluster is part of a MetroCluster configuration.
正解:A,D,E
質問 2:
Which two transport protocols would be used for SnapDrive for Windows in both 7-Mode and clustered Data ONTAP environments? (Choose two.)
A. HTTPS
B. RPC
C. HTTP
D. iSCSI
正解:A,D
質問 3:
An administrator on a clustered Data ONTAP 8.3.1 system created a FlexClone of a volume containing a LUN, but the new LUN Is offline and cannot be seen by the client.
In this scenario, which two actions will solve the problem? (Choose two.)
A. The LUN must be mapped to an initiator group.
B. The new volume must be split from the parent volume before the LUN can be used.
C. The LUN must be renamed to be different from the parent LUN.
D. The LUN needs to be brought online.
正解:A,D
質問 4:
What are two reasons to use HTTPS as the transport method for AutoSupport delivery for Active IQ? (Choose two.)
A. Only HTTPS transfers are compressed.
B. HTTPS is encrypted.
C. AutoSupport OnDemand (AOD) is supported.
D. HTTPS does not use a standard port.
正解:B,C
質問 5:
Referring to the exhibit, which two components should be examined? (Choose two.)
A. cluster switches
B. disk
C. SAS adapter
D. network interface card
正解:B,C
質問 6:
Which three conditions would prevent a normal giveback operation? (Choose three.)
A. ongoing SnapMirror updates
B. established CIFS sessions
C. LUNs mapped with ALUA enabled
D. presence of failed disks
E. established NFSv3 sessions
正解:A,B,D
質問 7:
You are on site to replace an I/O expansion module (IOXM) in a FAS6280 system. After replacement of the IOXM, you verify if the disks in the system are visible. You find that none of the cards in slots 7-13 are reporting.
In this scenario, which step did you forget when replacing the IOXM?
A. Shut down the power of the chassis.
B. Reseat the IOXM after initial replacement.
C. Boot into diagnostics to verify the IOXM.
D. Reassign all cards in the IOXM to the controller.
正解:C
Muraji -
試験への取り組み方が身についた気がします。自信を持って試験に臨めます。味にすごいね。Pass4Testさんまたお世話になりたいとおもいます。