最新なNetwork Appliance NS0-175問題集（277題）、真実試験の問題を全部にカバー！

質問 1：
Which command would you use to see the available option choices for the show config.http.acl command?
A. help config.acl
B. show config.http.acl.?
C. config.acl help
D. help
正解：B

質問 2：
You are asked to configure your company's new Cisco MDS switch so that the engineering department's FC storage traffic is logically isolated from the marketing department's traffic.
In this scenario, what will accomplish this task?
A. VLAN
B. VXLAN
C. VSAN
D. VPN
正解：C

質問 3：
An administrator plans to deploy a Nexus 1000V with VMware ESXi in a FlexPod environment. The administrator wants to ensure proper operation under multiple failure scenarios.
In this scenario, which two configuration actions conform to Cisco's best practices for high availability? (Choose two.)
A. Configure a dynamic vNIC policy on the service profile for the ESXi host.
B. Change the configuration of the UCS from end-host mode to switch mode.
C. Ensure that the Nexus 1000V control and data traffic are on different VLANs.
D. Disable fabric failover on the adapters in a UCS service profile.
正解：A,B

質問 4：
A customer wants to upgrade their code fabric between each site with a modular chassis switch that supports up to 400GbE per port to accommodate more business transaction volume.
In this scenario, which device would help them accomplish their objective?
A. Cisco Catalyst 9400
B. Cisco Nexus 9332C
C. Cisco Nexus 9504
D. Cisco MDS 9706
正解：C

質問 5：
Clustered Data ONTAP supports which three types of disk drives? (Choose three)
A. SSD
B. SAS
C. InfiniBand
D. HAS
E. SATA
正解：A,B,E

質問 6：
You are asked to build a FlexPod solution using Application Centric Infrastructure (ACI).
What are two ways to address the network requirements for high availability in this scenario? (Choose two.)
A. Deploy a single connected Cisco Application Policy Infrastructure Controller (APIC).
B. Configure virtual Port Channels (vPCs).
C. Use physical redundancy across the entire stack.
D. Deploy the infrastructure in two data centers.
正解：A,B

質問 7：
A customer wants to refresh their FlexPod solution by moving from 10 Gbps to 40 Gbps networking. They use FCoE to boot from SAN.
In this scenario, which statement is true?
A. FCoE is supported for 40 Gbps adapters
B. FCoE is supported on only 10 Gbps unified adapters
C. FCoE is supported for 25 Gbps adapters
D. FCoE is supported for 32 Gbps adapters
正解：A