最新なJuniper JN0-347問題集（138題）、真実試験の問題を全部にカバー！

質問 1：
Referring to the exhibit, which three actions would summarize these routes to a BGP peer? (Choose three.)

A. Create a policy that rejects the more specific contributing routes.
B. Create a policy to accept aggregate routes.
C. Create a route to 10.200.16.0/21 with a next hop of 172.16.36.1 under the [edit routing- options static] hierarchy.
D. Create a 10.200.16.0/22 route under the [edit routing-options aggregate] hierarchy.
E. Create a policy that accepts the more specific contributing routes.
正解：A,B,D

質問 2：
You manage a Layer 2 network that spans two buildings. You are asked to ensure that all traffic that traverses this connection between the two buildings is secured.
Which port security feature should be used to secure this Layer 2 traffic?
A. dynamic ARP inspection
B. MACsec
C. DHCP snooping
D. IP source guard
正解：B

質問 3：
Which statement is true about GRE tunnels?
A. Packets are encapsulated unchanged before entering the tunnel.
B. GRE tunnels can be used for only IP packets.
C. GRE tunnels support point-to-multipoint.
D. GRE tunnels ensure that a packet does not live forever.
正解：A

質問 4：
Click the Exhibit button. Based on the output shown in the exhibit, which statement is correct?

A. This switch has a bridge priority of 32k.
B. The ge-0/0/15 interface is using the default port cost.
C. This switch has been elected as the root bridge.
D. The ge-0/0/9 interface is using the default priority value.
正解：B
解説: (Pass4Test メンバーにのみ表示されます)

質問 5：
You notice that there are currently two MAC addresses associated with a single access port in the bridge table on one of your EX Series switches. What are two explanations for this behavior? (Choose two.)
A. The mac-move-limit feature has been disabled on the access port.
B. The native VLAN feature has been associated with the access port.
C. The access port connects to multiple hosts through a rogue device.
D. The access port connects to an IP phone which connects to a host device.
正解：B,C
解説: (Pass4Test メンバーにのみ表示されます)

質問 6：
Host-1 was recently added in the network and is attached to ge-0/0/10 on Switch-A.
Host-1 is powered on and has its interface configured with default Layer 2 settings and an IP address on the
172.17.12.0/24 IP subnet.
Host-1's MAC address is not shown in Switch-A's bridging table. What are three explanations for this state?
(Choose three.)
A. The ge-0/0/10 interface does not have an associated IRB.
B. The ge-0/0/10 interface is not operationally or administratively up.
C. The ge-0/0/10 interface is configured as a trunk port.
D. The ge-0/0/10 interface has not received any traffic from Host-1.
E. The ge-0/0/10 interface is configured as an access port.
正解：A,B,D
解説: (Pass4Test メンバーにのみ表示されます)