最新なJuniper JN0-650問題集（124題）、真実試験の問題を全部にカバー！

質問 1：
Click the Exhibit button.

Which statement about the configuration shown in the exhibit is correct?
A. The router is a rendezvous point for the 192.168.1.16 multicast source.
B. The router is configured as a static rendezvous point.
C. The router will not process PIM join messages.
D. The router is configured as a bootstrap router.
正解：B
解説: (Pass4Test メンバーにのみ表示されます)

質問 2：
You are enabling CoS throughout your enterprise network using the DSCP bits. You plan to use an MF classifier on all edge devices while using BA classifiers on all transit core devices. In this scenario, what should you use to provide consistent handling of traffic?
A. You should implement rewrite rules on the edge devices' egress interfaces to rewrite the DSCP bits as it leaves the device toward the core.
B. You should implement rewrite rules on the core devices' ingress interfaces to rewrite the DSCP bits as it enters the device.
C. You should implement rewrite rules on the edge devices' ingress interfaces to rewrite the DSCP bits as it enters the device.
D. You should implement rewrite rules on the core devices' egress interfaces to rewrite the DSCP bits as it leaves the device toward other core devices.
正解：A
解説: (Pass4Test メンバーにのみ表示されます)

質問 3：
Click the Exhibit button.

Referring to the exhibit, you see that the 0.0.0.0/0 route is coming from AS 64512.
What is the command to achieve this task?
A. show route receive-protocol bgp <peer ip> hidden
B. show route receive-protocol bgp <peer ip>
C. show route protocol bgp source-gateway <peer ip>
D. show route protocol bgp next-hop <peer ip>
正解：A
解説: (Pass4Test メンバーにのみ表示されます)

質問 4：
Click the Exhibit button.

You created a PVLAN between two EX Series switches and configured the ge-0/0/1 interface on both switches as trunk ports. You notice that traffic for community VLANs configured on both switches is not forwarded over the ge-0/0/1 trunk ports.
Referring to the exhibit, which action will solve this problem?
A. Configure the inter-switch-link parameter for the ge-0/0/1 interface on both switches.
B. Configure the core-facing parameter for the ge-0/0/1 interface on both switches.
C. Configure the vlan-auto-sense parameter for the ge-0/0/1 interface on both switches.
D. Configure the vlan-rewrite parameter for the ge-0/0/1 interface on both switches.
正解：A
解説: (Pass4Test メンバーにのみ表示されます)

質問 5：
While reviewing routing information on your router, you notice that the routing table has a hidden BGP route. In this scenario, what are two reasons for this behavior? (Choose two.)
A. The next hop for the route is unreachable.
B. The next hop is rewritten to self.
C. The AS path contains an entry of 0.
D. The AS path for EBGP is empty.
正解：A,C
解説: (Pass4Test メンバーにのみ表示されます)

質問 6：
You are deploying IP telephony in your enterprise network. Each office will have a handset and support for an additional network-attached end device. Both devices will be using network resources at the same time. Your company also requires that all end device-facing switch interfaces have 802.1X enabled. The handsets do not support 802.1X. In this scenario, which statement is correct?
A. Single-secure supplicant mode needs to be enabled on the switch interfaces.
B. LLDP will be allowed to pass, but LLDP-MED will be blocked.
C. 802.1X and LLDP cannot be configured on the same switch interface.
D. Single supplicant mode needs to be enabled on the switch interfaces.
正解：D
解説: (Pass4Test メンバーにのみ表示されます)