The modular Alpine switches support the following legacy WAN modules (Choose all three that apply)
A. 4-port E1(RJ-48) WAN Module
B. 1-port T3 (BNC) WAN Module
C. 4-port T1 (RJ-48) WAN Module
D. 4-port OC12/STM4 WAN Module
正解:A,B,C
質問 2:
An OSPF router type whose interfaces connect to two or more Autonomous Systems is called
A. Internal Router
B. BDR
C. ABR
D. None of these
正解:D
質問 3:
What information will the CLI Command show edp provide?
A. All of the above
B. The configured system names, Port numbers and VLANs of the remote Extreme switches
C. The EDP status of the local switch ports.
D. The MAC address of the remote systems connected.
正解:A
質問 4:
In an Extreme switch, all ports are enabled by default. If a port is disabled however, the link will also be disabled.
A. TRUE
B. FALSE
正解:B
質問 5:
What will this CLI command accomplish config vlan accounting protocol Appletalk?
A. It configures the VLAN accounting as a protocol-based VLAN and will filter out all protocols except AppleTalk
B. None of these
C. It adds a new predefined protocol vlan called Appletalk
D. It assigns Appletalk as one of the predefined protocols for use by the accounting VLAN
正解:A
質問 6:
In order to set the OSPF router ID to 192.168.0.1 in area 7.7.7.7 which of the following CLI commands should be used?
A. config ospf 192.168.0.1 routerid area 7.7.7.7
B. config 192.168.0.1 ospf routerid
C. config routerid ospf 192.168.0.1 area 7.7.7.7
D. config ospf routerid 192.168.0.1
正解:D
Shiraishi -
Pass4Testの問題集を購入させてEW0-200の試験に受かりました。まるで嘘のような的中率でした。ありがとうございます。