To enhance service in emergency situations, to which LLDP-MED Type-Length-Values does Forti-Switch advertise to IP phones?
A. Power management
B. Inventory management
C. Network policy
D. Location
正解:D
解説: (Pass4Test メンバーにのみ表示されます)
質問 2:
Exhibit.

port1 and port2 are the only ports configured with the same native VLAN 10.
What are two reasons that can trigger port1 to shut down? (Choose two.)
A. port1 was shut down by loop guard protection.
B. Loop guard frame sourced from port1 was received on port1.
C. STP triggered a loop and applied loop guard protection on port1.
D. An endpoint sent a BPDU on port1 that it received from another interface.
正解:A,B
質問 3:
Refer to the diagnostic output:

What makes the use of the sniffer command on the FortiSwitch CLI unreliable on__port__23?
A. Just the port egress payloads are printed on CLI.
B. Only untagged VLAN traffic can be captured.
C. The switch port might be used as a trunk member. When a switch port is configured as a trunk, it can carry traffic for multiple VLANs. If the sniffer is set up without specifying VLAN tags or a range of VLANs to capture, it may not accurately capture or display all the VLAN traffic due to the volume and variety of VLAN-tagged packets passing through the trunk port. This limitation makes using the sniffer on a trunk port unreliable for capturing specific VLAN traffic unless properly configured to handle tagged traffic.
D. The switch port might be used as a trunk member
E. The types of packets captured is limited.
正解:E
解説: (Pass4Test メンバーにのみ表示されます)
質問 4:
Exhibit.

What conditions does a FortiSwitch need to have to successfully configure the options shown in the exhibit above? (Choose two.)
A. The port full speed prior the split was 100G SFP+
B. The FortiSwitch model is equipped with a maximum of 54 interfaces.
C. The CLI commands are enabling a splitpo rt into four 10Gbps interfaces.
D. The split port can be assigned to native VLAN
正解:A,C
解説: (Pass4Test メンバーにのみ表示されます)
質問 5:
Which statement about the use of the switch port analyzer (SPAN) packet capture method is true?
A. Traffic on the management interface can be mirrored and captured by the monitoring device.
B. Mirrored traffic can be sent across multiple switches.
C. SPAN can be configured only on a standalone FortiSwitch.
D. The monitoring device must be connected to the same switch where the traffic is being mirrored
正解:B
解説: (Pass4Test メンバーにのみ表示されます)
質問 6:
Which statement about the IGMP snooping querier when enabled on a VLAN is true?
A. The setting can only be enabled using the FortiSwitch CLI.
B. All other indirectly connected switches will be unable to get IGMP multicast traffic.
C. Active multicast receiver entries are aging on each IGMP query sent on the VLAN
D. IGMP reports on the VLAN are forwarded to all switch ports.
正解:C
解説: (Pass4Test メンバーにのみ表示されます)
1238 お客様のコメント
クリック」





Miwa -
内容が分かり易いのはもちろん、重要なキーワードのNSE6_FSW-7.2解説がサイドの所に載っていて分かりやすかったです。