最新なNetwork Appliance NS0-183問題集（61題）、真実試験の問題を全部にカバー！

質問 1：
You are installing a new ONTAP 9.7 cluster by following the installation and setup poster. You are ready to complete the initial cluster setup. You have connected your laptop to the management switch. However, when browsing the network, you are unable to discover the ONTAP controllers.
Which statement explains this behavior?
A. You do not have a static IP address.
B. You do not have network discovery enabled.
C. You do not have IPv6 configuration set.
D. You do not have a default gateway set.
正解：B
解説: (Pass4Test メンバーにのみ表示されます)

質問 2：
Your customer wants a newly installed AFF C190 cluster to send SNMP notifications to a trap host called OVERWATCH01.
In this scenario, which two statements are correct? (Choose two.)
A. Configure a firewall policy and allow SNMP.
B. Configure an SNMP community string on the cluster.
C. Configure DNS on the cluster.
D. Configure a trap host on the cluster.
正解：C,D
解説: (Pass4Test メンバーにのみ表示されます)

質問 3：
You are planning to install a new ONTAP 9.7 All SAN Array (ASA) into your existing data center.
In this scenario, which cluster configuration is allowed with ASA controllers?
A. ASA controllers can only be added to clusters that have existing SAN licenses.
B. ASA controllers can only be installed as a standalone HA pair.
C. Add the ASA controllers to an existing 10-node cluster.
D. Add the ASA controllers to an existing 4-node cluster with NAS licenses.
正解：B
解説: (Pass4Test メンバーにのみ表示されます)

質問 4：
A customer has a current AFF ASA A700 cluster and they want to expand the cluster by adding a second AFF ASA A700 HA pair.
In this scenario, which step would be required to accomplish this task?
A. Install a BES-53248 cluster switch and convert the AFF ASA A700 from a switchless to switch cluster.
B. The customer will need to create a separate cluster for the second AFF ASA A700 pair.
C. Install a Brocade FC switch and create zoning between the original cluster and the new cluster.
D. Enable ALUA between the two HA pairs to allow cluster backend traffic.
正解：B
解説: (Pass4Test メンバーにのみ表示されます)

質問 5：
You must replace a FAS2750 switchless cluster with an AFF A220 switchless cluster for a customer. The customer requires that you transfer the data from the FAS2750 cluster to the AFF A220.
In this scenario, which two methods would you use to migrate the customer's data? (Choose two.)
A. Install SAS cables between the two clusters and use the vol move command.
B. Establish an SVM-DR relationship between the two clusters and activate the destination SVM.
C. Provide cluster switches and build a 4-node cluster, then use the vol move command.
D. Remove all of the HDD drives from the FAS cluster and install them into the AFF cluster.
正解：B,C