最新なJuniper JN0-363問題集（88題）、真実試験の問題を全部にカバー！

質問 1：
Which two statements ate correct about the BGP next-hop attribute value? (Choose two.)
A. By default, the next-hop value is changed across IBGP links.
B. By default, the next-hop value is not changed across EBGP links.
C. By default, the next-hop value is changed across EBGP links.
D. By default, the next-hop value is not changed across IBGP links.
正解：C,D
解説: (Pass4Test メンバーにのみ表示されます)

質問 2：
Which statement is correct about IS-IS?
A. IS-IS is a classful routing protocol.
B. IS-IS is a path vector routing protocol.
C. IS-IS is a link-state routing protocol.
D. IS-IS is a distance vector routing protocol.
正解：C
解説: (Pass4Test メンバーにのみ表示されます)

質問 3：
Exhibit

Which two statements are correct about the service provider MPLS network shown in the exhibit? (Choose two.)
A. R3 is considered a transit router.
B. R3 is considered an ingress router.
C. R3 is considered a P router.
D. R3 is considered a PE router.
正解：A,C
解説: (Pass4Test メンバーにのみ表示されます)

質問 4：
Which two interface types are used as tunnel endpoints? (Choose two.)
A. ge
B. gr
C. ip
D. ae
正解：B,C
解説: (Pass4Test メンバーにのみ表示されます)

質問 5：
You are adding an IPv6 configuration to an Interface on a Junos device.
In this scenario, which statement is correct?
A. The link local address must be manually configured within the fe80::/10 prefix range.
B. The link local address is automatically created using the MAC address within the fe80::'l0 prefix range.
C. The link local address must be manually configured within the fdO0::/8 prefix range.
D. The link local address is automatically created using the MAC address within the fd00::/8 prefix range.
正解：B
解説: (Pass4Test メンバーにのみ表示されます)

質問 6：
Which BGP message type is used to re-advertise routes that have already been sent to a peer and acknowledged using TCP?
A. refresh
B. update
C. notification
D. keepalive
正解：B
解説: (Pass4Test メンバーにのみ表示されます)

質問 7：
Exhibit.

Referring to the exhibit, you have configured an aggregate route that represents the 172.21.0.0/24, 172.21.1.0/24, and 172.21.2.0/24 networks. However, when you view the routing table, your new route hidden.
Which action would you perform to determine the problem?
A. Verify that you have active contributing routes on the device.
B. Verify that you have defined a metric value for the aggregate route.
C. Verify that you have set the preference to a lower default value.
D. Verify that you have configured a policy on the device to accept aggregate routes.
正解：C
解説: (Pass4Test メンバーにのみ表示されます)