746 お客様のコメント
質問 1：
Which of the following descriptions about ASPF and Server-map is correct?
A. The session table is a concrete reflection of the connection status of the two parties in the communication
B. When the firewall receives the message, it will check whether it matches the Server-map table
C. The Server-map table is generated by the firewall based on the session table
D. After the message hits the Server-map table, it needs to be controlled by the security policy
正解：C
質問 2：
When the IPv6 address of the host is configured in the stateless address configuration method, and other parameters except the address are obtained through DHCPv6, how to set the M bit and 0 bit in the RA message?
A. M=0 0=1
B. M=1 0=1
C. M=0 0=0
D. M=1 0=0
正解：A
質問 3：
Using NAT technology, only the network layer information (IP address) in the data packet can be translated.
A. TRUE
B. FALSE
正解：B
質問 4：
Regarding the range of BGP AS numbers, which of the following descriptions are incorrect? (Multiple choice)
A. When 4-byte AS is supported, no new attributes need to be defined
B. When 2-byte AS is supported, the value range of the private AS number is 64512-65535
C. When supporting 2-byte AS, the value range is 0-65535
D. When 2-byte AS is supported, the value range of the private AS number is 32768-65535
正解：A,C,D
質問 5：
Which of the following descriptions of 802.1X authentication technology in VLAN networks is incorrect?
A. Adopt a typical C/S architecture
B. The client must support EAPoL on the LAN
C. It is a port-based three-layer network access control protocol
D. Usually use RADIUS server as authentication server
正解：C
Which of the following descriptions about ASPF and Server-map is correct?
A. The session table is a concrete reflection of the connection status of the two parties in the communication
B. When the firewall receives the message, it will check whether it matches the Server-map table
C. The Server-map table is generated by the firewall based on the session table
D. After the message hits the Server-map table, it needs to be controlled by the security policy
正解：C
質問 2：
When the IPv6 address of the host is configured in the stateless address configuration method, and other parameters except the address are obtained through DHCPv6, how to set the M bit and 0 bit in the RA message?
A. M=0 0=1
B. M=1 0=1
C. M=0 0=0
D. M=1 0=0
正解：A
質問 3：
Using NAT technology, only the network layer information (IP address) in the data packet can be translated.
A. TRUE
B. FALSE
正解：B
質問 4：
Regarding the range of BGP AS numbers, which of the following descriptions are incorrect? (Multiple choice)
A. When 4-byte AS is supported, no new attributes need to be defined
B. When 2-byte AS is supported, the value range of the private AS number is 64512-65535
C. When supporting 2-byte AS, the value range is 0-65535
D. When 2-byte AS is supported, the value range of the private AS number is 32768-65535
正解：A,C,D
質問 5：
Which of the following descriptions of 802.1X authentication technology in VLAN networks is incorrect?
A. Adopt a typical C/S architecture
B. The client must support EAPoL on the LAN
C. It is a port-based three-layer network access control protocol
D. Usually use RADIUS server as authentication server
正解：C
仲程** -
Pass4Testさん、誠にありがとうございました！！！試験に合格っす。うれしいっす。