Which of the following Is the BEST reason for selecting a particular type of software development lifecycle model?
A. The project manager's preference
B. Tester skill level with the software development lifecycle model
C. The type of product being developed
D. The project team's overall familiarity with the model
正解:C
解説: (Pass4Test メンバーにのみ表示されます)
質問 2:
What is a defect density?
A. The percentage of defects identified over the total number of test cases
B. The deviation rate of the system from its expected behavior
C. The ratio of the defects identified in these system over the expected number of total defects
D. The number of defects identified in the system under test divided by the size of the system
正解:D
解説: (Pass4Test メンバーにのみ表示されます)
質問 3:
Which of the following would NOT be a typical target of testing support tools?
A. Automating repetitive inspections
B. Automate activities that require significant resources when done manually
C. Automate repetitive tasks
D. Automate activities that cannot be executed manually
正解:A
解説: (Pass4Test メンバーにのみ表示されます)
質問 4:
A program got 100% decision coverage in a test. Which of the following statements is then guaranteed to be true?
A. The "dead" code has not been covered.
B. Every output equivalence class has been tested.
C. Every input equivalence class has been tested.
D. Every executable statement is covered
正解:D
解説: (Pass4Test メンバーにのみ表示されます)
質問 5:
Which of the following statements about static analysis are FALSE?
I). Static analysis can be used instead of dynamic testing.
II). Static analysis can uncover defects like security vulnerabilities.
III). Static analysis can be used to check conformance to specifications and standards.
IV). Static analysis typically detects failures prior to component testing.
A. I. II
B. I. IV
C. II. III
D. III. IV
正解:A
解説: (Pass4Test メンバーにのみ表示されます)
質問 6:
The following sentences refer to the Standard for Software Test Documentation' specification (IEEE 829).
Which sentence is correct?
A. This test plan outline is relevant for military projects For consumer market projects there is a different specification with fewer items
B. Any deviation from this standard should be approved by management, marketing & development
C. The key to high quality test documentation regimes is strict adherence to this standard
D. Most test documentation regimes follow this spec to some degree, with changes done to fit a specific situation or organization
正解:D
解説: (Pass4Test メンバーにのみ表示されます)
質問 7:
Which of the following BEST defines risk level?
A. Risk level is determined by calculating the absolute value of the sum of all potential issues that may occur on the project
B. Risk level Is calculated by adding the probabilities of all planned risks to a project
C. Risk level Is determined by the likelihood of an event happening and the impact or harm from that event
D. Risk level Is calculated by dividing the sum of all known risks by the sum of all unknown risks
正解:C
解説: (Pass4Test メンバーにのみ表示されます)
質問 8:
Which of the following would you NOT expect to see on an incident report from test execution?
A. Expected results and actual results
B. The test execution schedule
C. Precise steps to reproduce the problem
D. The version(s) of the software under test
正解:B
解説: (Pass4Test メンバーにのみ表示されます)
質問 9:
What is the value of static code analysis?
A. Detection of suspicious operations caused by deviations from regulations
B. Detect deviations in standards by executing the source code
C. Early defect detection
D. Detection of failures not easily found by other types of testing
正解:C
解説: (Pass4Test メンバーにのみ表示されます)
Kudou -
出た試験対策問題集は解き方がよくわかる詳しい解説が好きです。CTFL_Syll2018参考書として、頼れる1冊です。