1021 お客様のコメント
質問 1：
When configuring
Ethernet Routing
Switch
(ERS) 8600 using the default interface, the attempt to load an ACLI configuration fails because the default interface is the CLI. How is the ACLI interface obtained?
A. Change the ACLI boot flag and save the boot configuration file.
B. Use the abort command and enter "no" at the default interface prompt
C. Change the interface type in the config.cfg file.
D. exits the CLI and chooses ACLI at the interface manager prompt.
正解：D
質問 2：
A technician is troubleshooting some IP telephones that are connected to an Ethernet Routing switch (ERS)
8300 8348TX-PWR I/O module.
The IP telephones will not turn on. The 48V LED on the module has been checked and it is steady amber.
A. 48V is present.
B. PoE is disabled.
C. 48V is not available.
D. Module is booting.
正解：D
質問 3：
Auto-negotiation should be enabled on all ports except under which condition?
A. When there is a mix of R and RS modules in the stack
B. When only the core Pitches support auto-negotiation
C. When there is a mix of 10 Mops and 1 Gbps end servers
D. When there are fiber ports in some end workstations
正解：B
質問 4：
IPFIX is protocol used for the export of flow information from traffic observed on a switch. Which true for the functioning of the IPIX protocol? (Choose two.)
A. The IPFIX information cannot be exported to a 3rd-party application.
B. The IPFIX exporter handles sending packets to the collectors.
C. The exporter can support up to 6 collectors
D. There is a command for exporting and flushing.
正解：B,D
質問 5：
A technician has implemented
Routed Split
Multi-Link Trunking
(RSMI I) edge design. After
recovering
power
outage
some clients
could
not communicate. It has been determined that only one of the core RSMLT switches has recovered. What should have been done to prevent
the loss communications?
A. Turn off the HoldDown timer.
B. Increase the Holdup timer to 9999.
C. Set the VLAN to copy RSMLT info from a similarly configured VLAN.
D. Clear the peer IP and MAC addresses
正解：D
When configuring
Ethernet Routing
Switch
(ERS) 8600 using the default interface, the attempt to load an ACLI configuration fails because the default interface is the CLI. How is the ACLI interface obtained?
A. Change the ACLI boot flag and save the boot configuration file.
B. Use the abort command and enter "no" at the default interface prompt
C. Change the interface type in the config.cfg file.
D. exits the CLI and chooses ACLI at the interface manager prompt.
正解：D
質問 2：
A technician is troubleshooting some IP telephones that are connected to an Ethernet Routing switch (ERS)
8300 8348TX-PWR I/O module.
The IP telephones will not turn on. The 48V LED on the module has been checked and it is steady amber.
A. 48V is present.
B. PoE is disabled.
C. 48V is not available.
D. Module is booting.
正解：D
質問 3：
Auto-negotiation should be enabled on all ports except under which condition?
A. When there is a mix of R and RS modules in the stack
B. When only the core Pitches support auto-negotiation
C. When there is a mix of 10 Mops and 1 Gbps end servers
D. When there are fiber ports in some end workstations
正解：B
質問 4：
IPFIX is protocol used for the export of flow information from traffic observed on a switch. Which true for the functioning of the IPIX protocol? (Choose two.)
A. The IPFIX information cannot be exported to a 3rd-party application.
B. The IPFIX exporter handles sending packets to the collectors.
C. The exporter can support up to 6 collectors
D. There is a command for exporting and flushing.
正解：B,D
質問 5：
A technician has implemented
Routed Split
Multi-Link Trunking
(RSMI I) edge design. After
recovering
power
outage
some clients
could
not communicate. It has been determined that only one of the core RSMLT switches has recovered. What should have been done to prevent
the loss communications?
A. Turn off the HoldDown timer.
B. Increase the Holdup timer to 9999.
C. Set the VLAN to copy RSMLT info from a similarly configured VLAN.
D. Clear the peer IP and MAC addresses
正解：D
川合** -
大学生ですが、この3605参考書を利用して一ヶ月で合格することができました。この参考書と過去問を解けば合格できると思います！