To which two Communication Manager forms are FRLs assigned? (Choose two.)
A. Station
B. Route Pattern
C. COR
D. COS
正解:B,C
解説: (Pass4Test メンバーにのみ表示されます)
質問 2:
Which two Statements are true about Automatic Route Selection (ARS)? (Choose two)
A. ARS routes calls only across tie trunks to local switching equipment.
B. ARS allows Communication Manager to use an ISDN trunk to connect to the PSTN.
C. ARS mutes calls across all trunk types but only to remote switching equipment
D. ARS routes calls to remote company locations in the absence of a private network.
正解:A,B
質問 3:
Security Violation show valid and invalid attempts to access the system using three types of codes.
In addition to station security codes, which two types of codes are measured in security Violation reports? (Choose two)
A. Dial access codes (DAC)
B. Access security gateway (ASG) codes
C. Barrier codes
D. Administrative login codes
E. Authorization codes
正解:C,E
質問 4:
In Communication Manager, in which way are alarms classified?
A. By the number of errors that appear
B. By the number of times the alarms are recorded
C. Whether the alarms are on-board or off-board
D. As a function of their effect on the system's operation
正解:D
解説: (Pass4Test メンバーにのみ表示されます)
質問 5:
You must verify in a production system that the number of rings between each point for coverage paths is two rings. You access the system-parameters coverage-forwarding from and check that the value for the local coverage Subsequent Redirection/ CFWD No Answer interval field is set to
2.Which users will be affected by this setting?
A. users belonging to a specific COR
B. users belonging to a specific COS-group
C. all users in the system
D. users belonging to a specific COS
正解:C
質問 6:
Which type of traffic does a DID trunk support?
A. Customer-provided equipment to the telephone system
B. Outgoing calls between telephone system and the local central office
C. Incoming calls routed directly to internal extensions
D. Incoming and outgoing calls between the telephone system and the local central office
正解:C
質問 7:
The monitor and display capacity commands can be used to get a real-time status of the system using Avaya Site Administration (ASA).
Which command and tool should you use to view a summary of the overall condition of the system?
A. Monitor system command using terminal emulationmode
B. Display status using GEPI or terminal emulationmode
C. Monitor status command using terminal emulationmode
D. Monitor system command using GEDI
正解:A
質問 8:
Which two Fields and Settings must be verified on the system-parameters customer-options form when adding 46xx or 96xx type telephones? (Choose two)
A. Maximum Concurrently Registered IP Stations greater than "0"
B. Digital Stations field In "y"
C. IP Stations field in "y"
D. Maximum Media Gateway VAL Sources greater than "0"
E. Maximum Off-PBX Telephones greater than "0"
正解:A,C
質問 9:

With reference to the Alarm Report shown in the exhibit, which option describes the location of the alarm that occurred on May 13 at 09:25?
A. gateway 1, server b, extension 1212
B. port network 1, cabinet b, carrier 12, slot 12
C. cabinet 1, carrier b, slot 12, port 12
D. server 1, gateway b, media module 12, port 12
E. cabinet 1, gateway b, media module 12, port 12
正解:C
716 お客様のコメント





远野** -
模擬試験の内容は大体90%以上に出題されました。感心しました。Pass4Testの皆様のおかげです。ありがとうございました。