When performing an active site survey in an existing WLAN infrastructure, in addition to gathering throughput data, what other important function will you typically be testing at the same time?
A. Roaming
B. ACL configuration
C. Application filtering
D. Internet bandwidth
正解:A
質問 2:
An engineering firm just upgraded their WLAN form nine 802.11n APS to nine 802.11ac APs. After this upgrade, they did not see any improvement in throughput. What is the most likely cause of this result?
A. The clients were not upgraded
B. APs are mounted on the wall
C. The APs are still using the 5 GHz lower band
D. APs are transmitting at a low transmit power
正解:D
質問 3:
What service must be implemented on your customers' network to authenticate users against an LDAP database prior to access to the WLAN infrastructure being granted?
A. SFTP
B. TLS
C. NTP
D. RADIUS
正解:D
質問 4:
During an RFP analysis, one of the vendors mentioned that you'll need to upgrade your Gigabit Ethernet switches to MultiGig switches to ensure support for 802.11ac and 802.11ax, which both offer data rates over
1Gbps. Why is this not sound advice?
A. Because 802.11ax doesn't support channel bonding
B. Management overhead that is normal in WLANs will reduce the throughput of the client devices
C. Because 802.11ac only supports one spatial stream
D. Because neither of the technologies support data rates over 1Gbps
正解:B
質問 5:
You performed a site survey with two USB Wi-Fi adapters using a special driver written for the site survey software. After deployment, you realized that the client devices used by your customer are getting lower RSSI values than that shown during your site survey. What is the most likely reason for this result?
A. The transmit power on the APs is higher than needed.
B. USB Wi-Fi adapters designed for site surveys may have better sensitivity than regular Wi-Fi cards installed in client devices.
C. Regular Wi-Fi cards installed in client devices do not support the same protocols as survey adapters.
D. USB Wi-Fi adapters have a greater sensitivity than internal Wi-Fi adapters.
正解:B
質問 6:
When installing APs on high ceilings, what should be the most common PPE to be used?
A. Clean suits, gloves and jacket
B. Glasses, gloves and jacket
C. Hardhat, high visibility vest and body belt
D. Clean suits, masks and glasses
正解:C
河野** -
出た試験対策問題集は解き方がよくわかる詳しい解説が好きです。CWDP-303参考書として、頼れる1冊です。