最新なVeritas VCS-254問題集（300題）、真実試験の問題を全部にカバー！

質問 1：
What should be considered before enabling the Preventing Concurrency Violation (ProPCV) attribute in a service group?
A. The ProPCV attribute is prevented from being changed when the service group is active.
B. The Mode value for the IMF attribute of the Application type resource is set to 1.
C. The MonitorProgram attribute must be configured for the Application resource type.
D. The MonitorProcesses attribute must be configured for the Application resource type.
正解：D

質問 2：
A two-node Veritas Cluster with I/O fencing configured has two service groups running, one on each node.
What happens when all heartbeat links are lost simultaneously?
A. All service groups remain where they are.
B. All nodes race for the data disks, and one node panics.
C. All service groups fault and shut down.
D. All nodes race for the coordinator disks, and one node panics.
正解：D

質問 3：
Which procedure must be followed to remove the resource type TypeA from an active VCS cluster?
A. Remove all resources of TypeA, remove TypeA, and remove TypeA packages
B. Execute the hatype -remove command which will remove all the resources
C. Stop VCS, remove all resources of TypeA, and start VCS
D. Remove TypeA, then execute the hatype esync command
正解：A

質問 4：
Under which circumstance should the ManageFaults service group attribute be set to NONE?
A. to place the resource in a STALE_ADMIN_WAIT state
B. to help in problem analysis when a resource faults
C. to prevent a hung resource from stopping a failover
D. to turn off manual control of a service group
正解：B

質問 5：
Which component is directly responsible for communicating online configuration changes to all nodes in the cluster?
A. HAD
B. IMF
C. LLT
D. GAB
正解：A

質問 6：
Refer to the exhibit.

Which two users can persistently freeze the service group group2? (Select two.)
A. barbara
B. aaron
C. georgia
D. edward
E. fung
F. carmen
正解：B,D

質問 7：
The hastatus command shows the systems are in STALE_ADMIN_WAIT. What causes this?
A. There is a syntax error in the main.cf configuration file.
B. There is a main.stale file in the configuration directory.
C. The main.cf is different on the systems in the cluster.
D. The configuration was not closed before restarting HAD.
正解：A