975 お客様のコメント
クリック」
質問 1：
Which of the following statements are true regarding VPN Manager? (Choose three.)
A. Common IPsec settings need to be configured only once in a VPN Community for all managed gateways.
B. VPN Manager automatically creates all the necessary firewall policies for traffic to be tunneled by IPsec.
C. VPN Manager automatically adds newly-registered devices to a VPN community.
D. VPN Manager must be enabled on a per ADOM basis.
E. VPN Manager can install common IPsec VPN settings on multiple FortiGate devices at the same time.
正解：A,D,E
質問 2：
An administrator would like to create an SD-WAN using central management. What steps does the administrator need to perform to create an SD-WAN using central management?
A. Remove all the interface references such as routes or policies
B. Enable SD-WAN central management in the ADOM, add member interfaces, create a static route and SDWAN firewall policies.
C. You must specify a gateway address when you create a default static route
D. First create an SD-WAN firewall policy, add member interfaces to the SD-WAN template and create a static route
正解：B
質問 3：
Refer to the exhibit.
An administrator has configured the command shown in the exhibit on FortiManager. A configuration change has been installed from FortiManager to the managed FortiGate that causes the FGFM tunnel to go down for more than 15 minutes.
What is the purpose of this command?
A. It allows FortiGate to unset central management settings.
B. It allows FortiGate to reboot and recover the previous configuration from its configuration file.
C. It allows the FortiManager to revert and install a previous configuration revision on the managed FortiGate.
D. It allows FortiGate to reboot and restore a previously working firmware image.
正解：B
質問 4：
View the following exhibit.
When using Install Config option to install configuration changes to managed FortiGate, which of the following statements are true? (Choose two.)
A. Once initiated, the install process cannot be canceled and changes will be installed on the managed device
B. Installs device-level changes to FortiGate without launching the Install Wizard
C. Provides the option to preview configuration changes prior to installing them
D. Will not create new revision in the revision history
正解：A,B
質問 5：
Which three settings are the factory default settings on FortiManager? (Choose three.)
A. port1 interface IP address is 192.168.1.99/24
B. Username is admin
C. FortiAnalyzer features are disabled
D. Password is fortinet
E. Reports and Event Monitor panes are enabled
正解：A,B,C
質問 6：
Which two statements about the scheduled backup of FortiManager are true? (Choose two.)
A. It backs up all devices and the FortiGuard database.
B. It does not back up firmware images saved on FortiManager.
C. It can be configured using the CLI and GUI.
D. It supports FTP, SCP, and SFTP.
正解：B,D
Which of the following statements are true regarding VPN Manager? (Choose three.)
A. Common IPsec settings need to be configured only once in a VPN Community for all managed gateways.
B. VPN Manager automatically creates all the necessary firewall policies for traffic to be tunneled by IPsec.
C. VPN Manager automatically adds newly-registered devices to a VPN community.
D. VPN Manager must be enabled on a per ADOM basis.
E. VPN Manager can install common IPsec VPN settings on multiple FortiGate devices at the same time.
正解：A,D,E
質問 2：
An administrator would like to create an SD-WAN using central management. What steps does the administrator need to perform to create an SD-WAN using central management?
A. Remove all the interface references such as routes or policies
B. Enable SD-WAN central management in the ADOM, add member interfaces, create a static route and SDWAN firewall policies.
C. You must specify a gateway address when you create a default static route
D. First create an SD-WAN firewall policy, add member interfaces to the SD-WAN template and create a static route
正解：B
質問 3：
Refer to the exhibit.
An administrator has configured the command shown in the exhibit on FortiManager. A configuration change has been installed from FortiManager to the managed FortiGate that causes the FGFM tunnel to go down for more than 15 minutes.
What is the purpose of this command?
A. It allows FortiGate to unset central management settings.
B. It allows FortiGate to reboot and recover the previous configuration from its configuration file.
C. It allows the FortiManager to revert and install a previous configuration revision on the managed FortiGate.
D. It allows FortiGate to reboot and restore a previously working firmware image.
正解：B
質問 4：
View the following exhibit.
When using Install Config option to install configuration changes to managed FortiGate, which of the following statements are true? (Choose two.)
A. Once initiated, the install process cannot be canceled and changes will be installed on the managed device
B. Installs device-level changes to FortiGate without launching the Install Wizard
C. Provides the option to preview configuration changes prior to installing them
D. Will not create new revision in the revision history
正解：A,B
質問 5：
Which three settings are the factory default settings on FortiManager? (Choose three.)
A. port1 interface IP address is 192.168.1.99/24
B. Username is admin
C. FortiAnalyzer features are disabled
D. Password is fortinet
E. Reports and Event Monitor panes are enabled
正解：A,B,C
質問 6：
Which two statements about the scheduled backup of FortiManager are true? (Choose two.)
A. It backs up all devices and the FortiGuard database.
B. It does not back up firmware images saved on FortiManager.
C. It can be configured using the CLI and GUI.
D. It supports FTP, SCP, and SFTP.
正解：B,D
Hazaki -
アプリ版も付いているので移動時の勉強にも最適効率的な学習がしやすい