An administrator is building a new VPC in Prism Central to isolate a test environment. The administrator plans to connect it to an external network later, but they want to complete the initial creation first.
Which configuration items are the minimum required to successfully create the VPC?
A. VPC name and cluster selection
B. VPC name and Transit VPC toggle switch
C. VPC name and one External Access VLAN
D. VPC name and one Overlay Subnet
正解:C
質問 2:
A customer wants to migrate VMs from a VLAN Basic Subnet to an Overlay Subnet with the same IP prefix.
Which migration approach ensures minimal disruption?
A. Change IPAM mode to unmanaged to allow manual IP assignment.
B. Enable trunk mode on VLAN to allow multiple subnets on the same interface.
C. Create a Layer 2 connectivity between the subnets and perform live migration.
D. Perform cold migration, acknowledging that ingress/egress connections will not be preserved.
正解:C
質問 3:
Refer to the exhibit.

An organization uses an FNS-NG Service Chain to steer application traffic through a pair of third-party firewall Network Function VMs operating in Active/Standby mode. Users suddenly report that all application access is blocked. The administrator reviews Prism Central -> Network & Security -> Network Functions, where the summary shown in the exhibit is displayed. Additional information: Alert: "Network Function 'PANW Service Insertion' virtual NIC pair(s) are unhealthy." Both firewall VMs are powered on and reachable. The security policy using the service chain has not been changed. Based on the exhibit and findings, what is the most likely cause of the traffic outage?
A. The service-chain health check failed to reroute sessions to the healthy firewall.
B. One of the Network Function vNIC pairs lost dataplane connectivity, interrupting traffic until health is stabilized.
C. Firewall policy synchronization was not configured when the standby firewall became active.
D. The inbound vNIC on SE-PA-VM Firewall-2 failed, preventing redirected packets from reaching the firewall.
正解:B
質問 4:
An administrator has created a VPC with the following subnets:
10.1.1.0/24
10.1.2.0/24
10.1.3.0/24
What action must be taken for these networks to be externally routable?
A. Assign a No-NAT External Network & ERP 10.1.0.0/22
B. Assign a No-NAT External Network & ERP 10.1.0.0/23
C. Assign a NAT external network & ERP 10.1.0.0/23
D. Assign a NAT External Network & ERP 10.1.0.0/22
正解:D
質問 5:
An administrator receives a ticket reporting unwanted traffic between production and development servers. The administrator reviews the Flow Network Security logs and finds the following:

How can the administrator resolve the issue?
A. Change the enforcement mode for the policy
B. Enable the Network Controller for the policy
C. Update the policy to disallow the unwanted traffic.
D. Move the servers to separate IP subnets.
正解:C
質問 6:
After creating a BGP session in Flow Virtual Networking, the session status remains down. Which log should an administrator use first in Prism Central to troubleshoot the issue?
A. Prism Central task execution logs
B. BGP Gateway system logs from the CVM
C. Routing Protocol Logs for the specific BGP session
D. Network and Security event logs related to connectivity changes
正解:C
質問 7:
What is the first step in preparing a Nutanix cluster for Flow Virtual Networking?
A. Install the Nutanix Flow Controller on all cluster nodes.
B. Install the latest version of Acropolis OS (AOS) on all nodes.
C. Enable the Network Controller in Prism Central.
D. Configure the VLANs on the physical network switches.
正解:C
質問 8:
Which prerequisite is required before enabling Flow Network Security Next-Gen micro segmentation?
A. The environment must use ESXi as the hypervisor.
B. Network Controller must be enabled in Prism Central.
C. A Flow license is optional and cannot be installed later.
D. All workloads should be on VLAN networks.
正解:B
1037 お客様のコメント





Arisugawa -
Pass4Testに書いた文字通り『出るとこだけ』ですね。NCP-NS本番試験の7割強を得点できました。