質問 1：
Dan is going to set up an IBM WebSphere Portal server only for developing self-contained portlets and portlet applications. Which of the following options is the best choice for this scenario?
A. Perform a base installation because self-contained portlets and portlet applications make a full installation unnecessary.
B. Perform a full installation and then run the ConfigEngine development-mode task.
C. Perform a full installation and then disable all the business portlets that are not needed during development.
D. Perform a full installation because self-contained portlets and portlet applications make a full installation necessary.
正解：A
質問 2：
IBM WebSphere Portal 8.0 Personalization sends published rules across HTTP to a servlet which resides on each personalization server. Which of the following statement is not a supported configuration?
A. Host and Target Systems on different network segments (VLAN)
B. Host and Target Systems in a clustered environment
C. Host and Target Systems on IPv6 protocol
D. Host and Target Systems connected to different LDAP's
正解：D
質問 3：
At a high level, which of the following options best describes the sequence of steps that one should take when setting up an IBM WebSphere Portal static cluster?
A. 1.Install WebSphere Portal on the first node, configure the database, and use the ConfigEngine tasks to create a profile template.
2.Prepare the first node to communicate WebSphere Application Server Network Deployment, and use addNode and ConfigEngine tasks to configure the cluster and user registry.
3.Install WebSphere Portal on additional nodes and use the profile template to configure.
4.Use the addNode and ConfigEngine tasks to federate the additional nodes and complete the cluster setup.
B. 1.Install and configure WebSphere Portal as a stand-alone node for each cluster node.
2.Federate each portal server node to the WebSphere Application Server Network Deployment cell using the addNode command.
3.Create a portal cluster using the ConfigEngine tasks.
4.Configure the cluster members to use the same database and user registry.
C. 1.Use WebSphere Application Server Network Deployment to create a cell and managed node for each portal node in the cluster.
2.Use the WebSphere Portal cluster profile template to install WebSphere Portal onto each node.
3.Use the ConfigEngine tasks to configure the nodes to use the same database and user registy.
4.Federate each of these nodes into the cluster by using the addNode and ConfigEngine tasks.
D. 1.Use WebSphere Application Server Network Deployment to create a managed node for each portal node in the cluster.
2.Federate each of these nodes into the WebSphere Application Server Network Deployment cell using the addNode command.
3.Install and configure WebSphere Portal on each portal server node.
4.Use ConfigEngine tasks to configure the database, user registry, and create the cluster.
正解：A
質問 4：
A portlet is available to multiple virtual portals. However, Noah does not want the marketing team virtual portal to utilize this portlet. Which of the following options offers the ability to restrict the portlet from the marketing team's virtual portal users?
A. Virtual Member Manager
B. Portlet security control
C. Virtual portal restriction
D. IBM WebSphere Portal access control
正解：D
質問 5：
Ryan has successfully built a new IBM WebSphere Portal environment utilizing IBM Lotus Domino as the LDAP directory source. He can successfully authenticate and access the portal. However, he is unable to create new groups. Which of the following options would be the cause of this issue?
A. The maximum Internet name and password setting for the Lotus Domino directory is set to Editor or higher.
B. The username utilized for authentication does not have access to create groups in Lotus Domino.
C. The IBM WebSphere Application Server must be installed on the Lotus Domino server for user registration to occur.
D. The portal server does not have the attribute LDAPDomino=1 set in wmmur.xml.
正解：B
質問 6：
If errors occur during the execution of ConfigEngine tasks, which of the following log files contain the trace information for diagnosing the configuration issues?
A. SystemOut.log
B. ConfigEngine.log
C. SystemErr.log
D. ConfigTrace.log
正解：D
質問 7：
Betty would like to setup a portal farm. What are the two types of supported configurations that she can choose when setting up a portal farm?
A. She can set up a unique installation where each farm has a unique installation or she can set up multiple instances that are shared between multiple farm instances.
B. She can clone installations where each farm is not a unique installation or she can set up multiple instances that are shared between multiple farm instances.
C. She can clone installations where each farm is not a unique installation or she can set up one instance that is shared between multiple farm instances.
D. She can set up a unique installation where each farm has a unique installation or she can set up one instance that is shared between multiple farm instances.
正解：D
質問 8：
In which order is the rendering done when using modularized themes?
A. Markup JavaScript code Static JavaScript configuration Dynamic JavaScript configuration CSS
B. Static JavaScript configuration Dynamic JavaScript configuration JavaScript code Markup CSS
C. CSS Static JavaScript configuration Dynamic JavaScript configuration JavaScript code Markup
D. CSS Dynamic JavaScript configuration Static JavaScript configuration JavaScript code Markup
正解：C
Dan is going to set up an IBM WebSphere Portal server only for developing self-contained portlets and portlet applications. Which of the following options is the best choice for this scenario?
A. Perform a base installation because self-contained portlets and portlet applications make a full installation unnecessary.
B. Perform a full installation and then run the ConfigEngine development-mode task.
C. Perform a full installation and then disable all the business portlets that are not needed during development.
D. Perform a full installation because self-contained portlets and portlet applications make a full installation necessary.
正解：A
質問 2：
IBM WebSphere Portal 8.0 Personalization sends published rules across HTTP to a servlet which resides on each personalization server. Which of the following statement is not a supported configuration?
A. Host and Target Systems on different network segments (VLAN)
B. Host and Target Systems in a clustered environment
C. Host and Target Systems on IPv6 protocol
D. Host and Target Systems connected to different LDAP's
正解：D
質問 3：
At a high level, which of the following options best describes the sequence of steps that one should take when setting up an IBM WebSphere Portal static cluster?
A. 1.Install WebSphere Portal on the first node, configure the database, and use the ConfigEngine tasks to create a profile template.
2.Prepare the first node to communicate WebSphere Application Server Network Deployment, and use addNode and ConfigEngine tasks to configure the cluster and user registry.
3.Install WebSphere Portal on additional nodes and use the profile template to configure.
4.Use the addNode and ConfigEngine tasks to federate the additional nodes and complete the cluster setup.
B. 1.Install and configure WebSphere Portal as a stand-alone node for each cluster node.
2.Federate each portal server node to the WebSphere Application Server Network Deployment cell using the addNode command.
3.Create a portal cluster using the ConfigEngine tasks.
4.Configure the cluster members to use the same database and user registry.
C. 1.Use WebSphere Application Server Network Deployment to create a cell and managed node for each portal node in the cluster.
2.Use the WebSphere Portal cluster profile template to install WebSphere Portal onto each node.
3.Use the ConfigEngine tasks to configure the nodes to use the same database and user registy.
4.Federate each of these nodes into the cluster by using the addNode and ConfigEngine tasks.
D. 1.Use WebSphere Application Server Network Deployment to create a managed node for each portal node in the cluster.
2.Federate each of these nodes into the WebSphere Application Server Network Deployment cell using the addNode command.
3.Install and configure WebSphere Portal on each portal server node.
4.Use ConfigEngine tasks to configure the database, user registry, and create the cluster.
正解：A
質問 4：
A portlet is available to multiple virtual portals. However, Noah does not want the marketing team virtual portal to utilize this portlet. Which of the following options offers the ability to restrict the portlet from the marketing team's virtual portal users?
A. Virtual Member Manager
B. Portlet security control
C. Virtual portal restriction
D. IBM WebSphere Portal access control
正解：D
質問 5：
Ryan has successfully built a new IBM WebSphere Portal environment utilizing IBM Lotus Domino as the LDAP directory source. He can successfully authenticate and access the portal. However, he is unable to create new groups. Which of the following options would be the cause of this issue?
A. The maximum Internet name and password setting for the Lotus Domino directory is set to Editor or higher.
B. The username utilized for authentication does not have access to create groups in Lotus Domino.
C. The IBM WebSphere Application Server must be installed on the Lotus Domino server for user registration to occur.
D. The portal server does not have the attribute LDAPDomino=1 set in wmmur.xml.
正解：B
質問 6：
If errors occur during the execution of ConfigEngine tasks, which of the following log files contain the trace information for diagnosing the configuration issues?
A. SystemOut.log
B. ConfigEngine.log
C. SystemErr.log
D. ConfigTrace.log
正解：D
質問 7：
Betty would like to setup a portal farm. What are the two types of supported configurations that she can choose when setting up a portal farm?
A. She can set up a unique installation where each farm has a unique installation or she can set up multiple instances that are shared between multiple farm instances.
B. She can clone installations where each farm is not a unique installation or she can set up multiple instances that are shared between multiple farm instances.
C. She can clone installations where each farm is not a unique installation or she can set up one instance that is shared between multiple farm instances.
D. She can set up a unique installation where each farm has a unique installation or she can set up one instance that is shared between multiple farm instances.
正解：D
質問 8：
In which order is the rendering done when using modularized themes?
A. Markup JavaScript code Static JavaScript configuration Dynamic JavaScript configuration CSS
B. Static JavaScript configuration Dynamic JavaScript configuration JavaScript code Markup CSS
C. CSS Static JavaScript configuration Dynamic JavaScript configuration JavaScript code Markup
D. CSS Dynamic JavaScript configuration Static JavaScript configuration JavaScript code Markup
正解：C
0 お客様のコメント