最新なAlcatel-Lucent 4A0-M02問題集（140題）、真実試験の問題を全部にカバー！

質問 1：
Which of the following statements is FALSE regarding the S1-based handover?
A. Direct data forwarding via the X2 interface may be used.
B. None of the above statements are false.
C. The MME may be relocated.
D. Indirect data forwarding via the SGW may be used.
E. The SGW may be relocated.
正解：B

質問 2：
Based on the information shown in the exhibit, which of the following is TRUE when the PGW receives a "Create Session Request" with the "PDNTYPE" set to IPv4?

A. The PGW tries to allocate an IP address from the subnet "5.5.0.0/16" and assigns it to the UE.
B. There is insufficient information to answer this question.
C. The "Create Session Request" isrejectedby the PGW.
D. The PGW tries to allocate an IP address from the subnet "3FFE::/48" and assigns it to the UE.
正解：C

質問 3：
Which of the following statements are TRUE regarding the Predefined PCC rules? (Choose two)
A. The Predefined PCC rules areactivatedor deactivatedby the PCEF at any time.
B. The Predefined PCC rules areactivatedor deactivatedby the PCRF at anytime.
C. The Predefined PCC rules are preconfigured on the PCRF.
D. The Predefined PCC rules are preconfigured on the MME.
E. The Predefined PCC rules are preconfigured on the PCEF.
正解：B,E

質問 4：
Which of the following is the message used to detect a transport failure over a Diameter connection?
A. The Credit-Control message
B. The Device-Watchdog message
C. The Capabilities-Exchange message
D. None of the above answers are correct
E. The Disconnect-Peer message
正解：B

質問 5：
Which of the following most accurately describes the CPM modules on an Alcatel-Lucent 7750 MG?
A. Two CPM modules can be installed on an Alcatel-Lucent 7750 MG node. One CPM is in active state while the other is in hot-standby state.
B. The CPM modules always choose the same MG-ISM group to handle all the bearers of a given UE.
C. All of the above answers are correct.
D. The CPM modules are responsible for load balancing the EPS bearers.
E. The CPM module also includes the Switch Fabric function for the Alcatel-Lucent 7750 MG.
正解：C

質問 6：
Which of the following statements is FALSE regarding the Gx interface?
A. The PCEF receives the QoS information for a bearer from the PCRF over the Gx interface.
B. It is never used to transport user data packets.
C. It is a Diameter-based interface between the PCRF and the PCEF.
D. It runs a vendor specific application identified by an application ID value of 16777238.
E. The PCEF can act as a client or as a server for the Diameter connection depending on which application is running over the Gx interface.
正解：E

質問 7：
Which of the following does not apply during the CPM selection of an MG-ISM card?
A. All of the above statements apply.
B. TheselectedMG-ISM card is responsible for bearer management andTEIDassignment.
C. All sessions established for a given UE are handled by the same MG-ISM group.
D. The CPM load balances amongst all configured MG-ISM groups.
E. The CPM load balances based on the number of sessions currently handled by each MG-ISM group
正解：D

質問 8：
Based on the information shown in the exhibit, what is the TEID value 0xd06015 used for?

A. This TEID value is used by the SGW when sending downlink data traffic to the target eNodeB.
B. This TEID value is used by the source eNodeB when sending downlink data traffic back to the SGW.
C. This TEID value is used by the target eNodeB when sending uplink data traffic to the SGW.
D. This TEID value is used by the SGW when sending downlink data traffic to the source eNodeB.
E. This TEID value is used by the source eNodeB when sending uplink data traffic to the SGW.
正解：B