An LTM Specialist needs to enable TCP connection re-use for a non-HTTP application. The application uses a simple request response protocol where each request and response is contained within a single packet.
Which configuration option should the LTM Specialist adjust?
A. use a Performance (Layer 4) Virtual Server
B. increase the connection limit for pool members
C. assign a OneConnect profile
D. increase the idle Timeout in a custom TCP profile
正解:C
質問 2:
An LI M device is experiencing a high volume of traffic. The virtual server is struggling under the load. The problem appears to be on the server side connections. The virtual server is accepting connections . The virtual server is accepting connections on https and is configured with an SSL profile and http pool.
What should be added to increase the performance of the device?
A. smaller key to the SSL profile
B. a SPDY profile
C. an HTTP Compression profile
D. a One Connect profile
正解:D
質問 3:
A virtual server configuration for traffic destined to a server is as shown:

FTP traffic is destined to the 192.168.1.101 server from the source of 192.168.2.129.
Based on precedence, which virtual server accepts this traffic?
A. MyVS1
B. MyV53
C. MyVS2
D. MyVS4
正解:C
質問 4:
Exhibit.

Webserver_pool consists of 6 members. phpAuction_80_pool consists of 2 members LTM1 is the current Active member.
LTM1 loses connectivity to 3 of the 6 members in the webserver_pool LTM2 still has connectivity to all servers.
What is the expected failover behavior?
A. LTM1 Standby / LTM2 Standby
B. LTM1 Active /LTM2 Active
C. LTM1 Standby / LTM2 Active
D. LTM1 Active / LTM2 Standby
正解:D
質問 5:
An LTM Specialist needs to assign a health monitor to a pool with two pool members 10.10.10 101 and 10.10.10.102 Both pool members are listening on port 8080 with TCP. The health of the application depends on the health of an another server (10 10 10 100) that runs port 9080 with TCP.
Which two custom TCP monitors should be selected as the pool's health monitors' (Choose two)
A. a custom TCP monitor that works on port 9080,
B. a custom TCP monitor that works on port 9080 with 10.10.10.100 as alias address
C. a custom TCP monitor that works on port 8080
D. a custom TCP monitor that works on port 8080 with 10.10.10.102 is alias address
E. a custom TCP monitor that works on port 9080 with 10,10.10.101 as alias address
F. a custom TCP monitor that works on port 8080 with 10.10.10.101 as alias address
正解:B,C
質問 6:
An LTM Specialist needs to provide statistics regarding the round-trip time between the clients and the servers.
Which metric should be part of the analytics profile to provide that information?
A. Max TPS and Throughout
B. Page Load Time
C. User Sessions
D. Response Codes
正解:B
質問 7:
An LTM Specialist needs to configure a setup for antivirus scanning of HTTP traffic with an internet Contact adaption Protocol (ICAP) server.
Which two server type should be used? (Choose two.)
A. Internal
B. Stateless
C. Standard
D. Performance HTTP
E. Forwarding IP
正解:A,C
質問 8:
An SSL application is being migrated to the LTM device. Both encrypted and unencrypted traffic are accepted by the server. The virtual server configuration is as follows:

Which LTM device profile should be used on the LTM device to reduce the CPU load on the current.
A. serverssl
B. stream
C. Protocol
D. clientsssl
正解:D
徳永** -
301aを受験しました。素晴らしい的中率でした。ありがとうございました。