最新なRiverbed 299-01問題集（245題）、真実試験の問題を全部にカバー！

質問 1：
In this scenario, you have created a host group called My_Computers on Cascade Profiler. In that group you have included the subnet 192.168.1.0/25.
You have 10 devices in that group 192.168.1.1-10. The rest of the addresses are unused. While running reports on this segment of the network you notice that when a report is run using the entire subnet you see traffic destined for 192.168.1.120. When you run the same report specifying the host group the traffic does not appear. Why is this happening?
A. Traffic to 192.168.1.120 was not picked up by a Gateway
B. 192.168.1.120 never sent any traffic
C. Traffic to 192.168.1.120 was not picked up by a Sensor
D. 192.168.1.120 has been input as a trusted host in a security policy
E. 192.168.1.120 is not in the 192.168.1.0/25 subnet
正解：B

質問 2：
Which content block can be used to compare traffic between two time periods on the Cascade Profiler Dashboard?
A. Top list as a bar chart
B. Watched list as a bar chart
C. Watched list as a pie chart
D. Watched list as a line graph
E. Watched list as a stacked area chart
正解：B

質問 3：
What does Cascade use as the flow key to identify a unique flow?
A. sourceIP, destIP, protocol, sourcePort, destPort
B. sourceIP, destIP, protocol, sourcePort, destPort, QoS
C. sourceIP, destIP, protocol
D. sourceIP, destIP, protocol, destPort
E. destIP, protocol, destPort
正解：A

質問 4：
Filtering in Cascade Pilot: (Select 2)
A. Can be changed after applying a View.
B. Can be created from a chart.
C. Is the equivalent of the Wireshark "display filter input".
D. Is either a BPF or Wireshark Display filter only.
正解：A,B
解説: (Pass4Test メンバーにのみ表示されます)

質問 5：
Which of the following metrics can Cascade Profiler create dependency (Connection Graphs) for? (Select 3)
A. Average retransmits
B. Average utilization
C. Average drops
D. Average response time
E. Total bandwidth bits
正解：A,D,E

質問 6：
When saving a new application performance analytic on Cascade Profiler, which of the following is true?
A. You must have at least three days of history of 15 minute rollups before the analytic initializes.
B. If you include all possible metrics, but there is no possibility of measuring response time due to lack of Sensor coverage, the analytic will fail to initialize.
C. Both B and C.
D. You must have at least three days of history of 15 minute rollups before saving the analytic.
E. The analytic will not alert for a minimum of 1 week during baseline collection.
正解：A

質問 7：
How are trace clips created in Cascade Pilot? (Select 2)
A. Select a time window and apply a Cascade Pilot filter.
B. Select a Capture Job, right-click, and select "Create Trace Clip".
C. Click the + button in the Capture Job item and select a time window.
D. Drag a bar from a Bar Chart to the Capture Job.
正解：B,C