When configuring Zone Based Dialing, what option would you select to create new zones for routing calls through a centralized Call Server?
A. Numbering Zones link
B. Bandwidth Zones link
C. Dialing Configuration Details for Flexible Dial Plan link
D. Dialing Configuration Details link
正解:C
質問 2:
Click the Exhibit button.
Given a customer's Coordinating Dialing Plan shown in the exhibit, if a Station user at CDP Switch #2 dials 327-3249, which route list used and where will the call terminate?
A. Route List 10 will be utilized and the call will terminate at CDP Switch #3
B. Route List 2 will be utilized and the call will terminate at CDP Switch #2
C. Route List 1 will be utilized and the call will terminate at CDP Switch #3
D. Route List 5 will be utilized and the call will terminate at CDP Switch #2
正解:B
質問 3:
Given the following network characteristics:
three Communication Server 1000 RIs. 7 x systems IP Peer Networking required DN uniqueness cannot be maintained route calls using site Location Codes (LOCs)
Which type of dialing plan is recommended for this call routing scenario?
A. Coordinated Dialing Plan (CDP)
B. Uniform Dialing Plan (UDP)
C. Flexible Numbering Plan (FNP)
D. Network Attendant Numbering Plan
正解:C
質問 4:
Click the Exhibit button.
A customer has asked if the Communication Server 1000 RIs. 7 x system can route anyone that dial an unassigned number in the customer's DID range to the Attendant.
In reviewing the current configuration as shown in the exhibit, what do you conclude?
(Choose two)
A. NET_DATA Attendant and tie trunk users are receiving an overflow tone
B. internal station users and non tie line users are routing to the Attendant
C. all caller types are receiving an overflow tone
D. only internal station users are routing to the Attendant
正解:B
質問 5:
Click the Exhibit button.
A customer wants to allow a station user to save an incoming number (Off-Net, Local Number) to their Personal Directory and afterwards use it to place an outgoing call without having to perform an manual manipulation to the number.
Consider the customer dialing plan shown in the exhibit.
Communication Server 1000 is configured for DAPC = YES in the Route Data Block.
With reference to the DAPC Table options in the exhibit, which Dial Access Prefix on CLID (DAPC) table should be used?
A. Table 2
B. Table 3
C. Table 4
D. Table 1
正解:B
質問 6:
A customer site has a Communication Server 1000 system located at us main campus and wants to network me system for direct calls with a system in a different city.
Which type of steering code is required to route calls over specify trunk routes between the two sites?
A. Special Number (SPN)
B. Network Plan Area (NPA)
C. Remote Steering Code (RSC)
D. Distant Steering Code (DSC)
正解:D
Sai -
これで合格点は取れます。問題部分だけの暗記でもいけるレベルです。Pass4Testは信頼できます。