The following configuration is for VPN-1 NGX:1s this configuration correct for Management High Availability (HA)?
A. No, a VPN-1 NGX SmartCenter Server cannot run on Red Hat Linux 7.3.
B. No, A VPN-1 NGX SmartCenter Server can only be in a Management HA configuration, if the operating system is Solaris.
C. No, the SmartCenter Servers must reside on the same network.
D. No, the SmartCenter Servers do not have the same number of NICs.
E. No, the SmartCenter Servers must be installed on the same operating system.
正解:E
質問 2:
You are running the license_upgrade tool on your SecurePlatform Gateway. Which of the following can you NOT do with the upgrade tool?
A. Perform the actual license-upgrade process.
B. View the status of currently installed licenses.
C. Simulate the license-upgrade process.
D. View the licenses in the SmartUpdate License Repository.
正解:D
質問 3:
The User Directory Software Blade is used to integrate which of the following with a R76 Security Gateway?
A. LDAP server
B. RADIUS server
C. Account Management Client server
D. UserAuthority server
正解:A
質問 4:
SmartWorkflow has been enabled with the following configuration:
If a security administrator opens a new session and after making changes to policy, submits the session for approval will be displayed as:
A. Not Approved
B. In progress
C. Awaiting Approval
D. Approved
正解:B
質問 5:
You have selected the event Port Scan from Internal Network in SmartEvent, to detect an event when 30 port scans have occurred within 60 seconds. You also want to detect two port scans from a host within 10 seconds of each other. How would you accomplish this?
A. You cannot set SmartEvent to detect two port scans from a host within 10 seconds of each other.
B. Select the two port-scan detections as a sub-event.
C. Select the two port-scan detections as a new event.
D. Define the two port-scan detections as an exception.
正解:D
質問 6:
You want only RAS signals to pass through H.323 Gatekeeper and other H.323 protocols, passing directly between end points. Which routing mode in the VoIP Domain Gatekeeper do you select?
A. Direct
B. Direct and Call Setup
C. Call Setup and Call Control
D. Call Setup
正解:A
質問 7:
What is the router command to save your OSPF configuration?
A. save
B. write mem
C. write config
D. save memory
正解:B
質問 8:
John is configuring a new R76 Gateway cluster but he can not configure the cluster as Third Party IP Clustering because this option is not available in Gateway Cluster Properties.
What's happening?
A. John has an invalid ClusterXL license.
B. Third Party Clustering is not available for R76Security Gateways.
C. ClusterXL needs to be unselected to permit 3rd party clustering configuration.
D. John is not using third party hardware as IP Clustering is part of Check Point's IP Appliance.
正解:C
チ*ワ -
問題の解説部分でも語句説明が丁寧なのでインプットもしやすい点も良いと思います。確実に156-315.13勉強したいかたにおすすめです。