Which of the following is NOT a back up method?
A. System backup
B. snapshot
C. Migrate
D. Save backup
正解:D
解説: (Pass4Test メンバーにのみ表示されます)
質問 2:
When using GAiA, it might be necessary to temporarily change the MAC address of the interface eth 0 to
00:0C:29:12:34:56. After restarting the network the old MAC address should be active. How do you configure this change?
A. Edit the file /etc/sysconfig/netconf.C and put the new MAC address in the field(conf:(conns:(conn:hwaddr ("00:0C:29:12:34:56")
B. As expert user, issue these commands:# IP link set eth0 down# IP link set eth0 addr 00:0C:29:12:34:56# IP link set eth0 up
C. Open the WebUI, select Network > Connections > eth0. Place the new MAC address in the field Physical Address, and press Apply to save the settings.
D. As expert user, issue the command:# IP link set eth0 addr 00:0C:29:12:34:56
正解:D
質問 3:
Fill in the blank: ____________ is the Gaia command that turns the server off.
A. exit
B. shut-down
C. sysdown
D. halt
正解:D
質問 4:
Tom has connected to the R80 Management Server remotely using SmartConsole and is in the process of making some Rule Base changes, when he suddenly loses connectivity. Connectivity is restored shortly afterward. What will happen to the changes already made:
A. Tom will have to reboot his SmartConsole computer, and access the Management cache store on that computer, which is only accessible after a reboot.
B. Tom's changes will have been stored on the Management when he reconnects and he will not lose any of this work.
C. Tom's changes will be lost since he lost connectivity and he will have to start again.
D. Tom will have to reboot his SmartConsole computer, clear the cache and restore changes.
正解:B
質問 5:
How do you manage Gaia?
A. Through CLI and WebUI
B. Through SmartDashboard only
C. Through CLI, WebUI, and SmartDashboard
D. Through CLI only
正解:C
メロ** -
読みやすく わかりやすい解説
これで156-215.80試験に受かる気がした。