9 お客様のコメント
質問 1：
You are asked to deploy a Versa Secure SD-WAN branch for 1000 locations. You need to profile the branches based on common deployment requirements.
In this scenario, which three configuration objects would be shared by multiple appliances? (Choose three.)
A. device groups
B. device bind data
C. workflow device
D. service templates
E. device templates
正解：A,D,E
解説: (Pass4Test メンバーにのみ表示されます)
質問 2：
Examine the CLI output in the exhibit.
You are reviewing the OSPF adjacency on a VOS CPE, and the output is shown in the exhibit. In this scenario, what is the probable cause of the OSPF adjacency issue?
A. There is an interface MTU mismatch between the OSPF peers.
B. There is no bidirectional communication between the OSPF peers.
C. There is a filter configured on the peer that is dropping 224.0.0.5 traffic.
D. There is an OSPF area mismatch between the peers.
正解：A
解説: (Pass4Test メンバーにのみ表示されます)
質問 3：
Examine the exhibit below.
A DoS Profile shown in the exhibit is applied to an SD-WAN branch.
Referring to the exhibit, which statement is correct?
A. Packets are completely dropped if TCP throughput is 7000 packets per second.
B. Packets are randomly dropped if TCP throughput is 7000 packets per second.
C. Packets are completely dropped if TCP throughput is 5000 packets per second.
D. An alarm is generated if TCP throughput is 7000 packets per second.
正解：B
解説: (Pass4Test メンバーにのみ表示されます)
質問 4：
A branch user reports poor throughput over an SD-WAN tunnel. The command show interfaces detail vni-0/0 shows the interface is operating at half-duplex / 100 Mbps , although the circuit is expected to run at 1 Gbps full duplex. What is the most likely cause?
A. SD-WAN SLA probing is disabled.
B. VXLAN encapsulation is missing on the overlay.
C. The Controller is not advertising branch routes.
D. There is an underlay link speed or duplex mismatch.
正解：D
質問 5：
As an administrator, you are migrating your legacy WAN to Versa Secure SD-WAN without changing the underlay network. You need to ensure that, during the migration process, legacy WAN sites are allowed to communicate with SD-WAN branches. Which two steps should be implemented to accomplish this task?
(Choose two.)
A. Using workflows, configure the Gateway option in the hub template for the underlay links.
B. Apply the Spoke-to-Spoke-Direct topology for the SD-WAN branches.
C. Configure BGP on the hub underlay links to advertise and receive the prefixes.
D. Configure an SD-WAN traffic steering policy to advertise the SD-WAN routes.
正解：A,C
解説: (Pass4Test メンバーにのみ表示されます)
You are asked to deploy a Versa Secure SD-WAN branch for 1000 locations. You need to profile the branches based on common deployment requirements.
In this scenario, which three configuration objects would be shared by multiple appliances? (Choose three.)
A. device groups
B. device bind data
C. workflow device
D. service templates
E. device templates
正解：A,D,E
解説: (Pass4Test メンバーにのみ表示されます)
質問 2：
Examine the CLI output in the exhibit.
You are reviewing the OSPF adjacency on a VOS CPE, and the output is shown in the exhibit. In this scenario, what is the probable cause of the OSPF adjacency issue?
A. There is an interface MTU mismatch between the OSPF peers.
B. There is no bidirectional communication between the OSPF peers.
C. There is a filter configured on the peer that is dropping 224.0.0.5 traffic.
D. There is an OSPF area mismatch between the peers.
正解：A
解説: (Pass4Test メンバーにのみ表示されます)
質問 3：
Examine the exhibit below.
A DoS Profile shown in the exhibit is applied to an SD-WAN branch.
Referring to the exhibit, which statement is correct?
A. Packets are completely dropped if TCP throughput is 7000 packets per second.
B. Packets are randomly dropped if TCP throughput is 7000 packets per second.
C. Packets are completely dropped if TCP throughput is 5000 packets per second.
D. An alarm is generated if TCP throughput is 7000 packets per second.
正解：B
解説: (Pass4Test メンバーにのみ表示されます)
質問 4：
A branch user reports poor throughput over an SD-WAN tunnel. The command show interfaces detail vni-0/0 shows the interface is operating at half-duplex / 100 Mbps , although the circuit is expected to run at 1 Gbps full duplex. What is the most likely cause?
A. SD-WAN SLA probing is disabled.
B. VXLAN encapsulation is missing on the overlay.
C. The Controller is not advertising branch routes.
D. There is an underlay link speed or duplex mismatch.
正解：D
質問 5：
As an administrator, you are migrating your legacy WAN to Versa Secure SD-WAN without changing the underlay network. You need to ensure that, during the migration process, legacy WAN sites are allowed to communicate with SD-WAN branches. Which two steps should be implemented to accomplish this task?
(Choose two.)
A. Using workflows, configure the Gateway option in the hub template for the underlay links.
B. Apply the Spoke-to-Spoke-Direct topology for the SD-WAN branches.
C. Configure BGP on the hub underlay links to advertise and receive the prefixes.
D. Configure an SD-WAN traffic steering policy to advertise the SD-WAN routes.
正解：A,C
解説: (Pass4Test メンバーにのみ表示されます)
水嶋** -
VNX301試験参考書は本当に有効です！初めてVNX301試験に参加し、VNX301試験に合格しました。驚きました！