最新なJuniper JN0-480問題集（67題）、真実試験の問題を全部にカバー！

質問 1：
Which statement is true when onboarding a Juniper Networks device using a Juniper Apstra ZTP server?
A. The Management IP address cannot be predetermined.
B. The Hostname will be the serial-number of the device.
C. The State can be set In the ztp.Json file on the ZTP server.
D. The Device Key lo be used can be set In the dhcpd.conf file on the ZTP server.
正解：C
解説: (Pass4Test メンバーにのみ表示されます)

質問 2：
Which three statements describe intent-based analytics? (Choose three.)
A. It is used to establish network performance baselines.
B. It is a real-time information processing pipeline.
C. It indicates when device operating versions require updating.
D. It collects information from vendor websites.
E. It alerts the network operator when network performance moves away from the baseline.
正解：A,B,E
解説: (Pass4Test メンバーにのみ表示されます)

質問 3：
Exhibit.

Referring to the exhibit, which statement is correct?
A. The gray-solid primitives indicate further configuration is requited.
B. The red-striped primitives indicate that they are incompatible with the connectivity template design.
C. The red-striped primitives indicate that further configuration is required.
D. The gray-solid primitives indicate that they ate incompatible with the connectivity template design.
正解：C
解説: (Pass4Test メンバーにのみ表示されます)

質問 4：
Which protocol is used to advertise EVPN routes?
A. OSPF
B. RIP
C. IS-IS
D. BGP
正解：D
解説: (Pass4Test メンバーにのみ表示されます)

質問 5：
You want to keep virtual networks isolated from each other within the Juniper Apstra system.
In this scenario, what are three ways to accomplish this task? (Choose three.)
A. Disable IPv4 connectivity when creating the virtual network within the same Routing Zone.
B. Disable Route Target exports when creating the Routing Zones.
C. Put each network in different Routing Zones.
D. Use Connectivity Templates to block access within the same Routing Zone.
E. Enable Security Policy for virtual networks in the same Routing Zone.
正解：C,D,E
解説: (Pass4Test メンバーにのみ表示されます)

質問 6：
What is the purpose of an interface map in Juniper Apstra?
A. An interface map specifies a connection between the interfaces of two devices.
B. An interface map specifies the connections between racks in a template.
C. An interface map specifies the number of ports and the port speeds of a logical device
D. An interface map associates a logical device with a device profile.
正解：A
解説: (Pass4Test メンバーにのみ表示されます)

質問 7：
Which statement is correct about making changes to a predefined device profile in Juniper Apstra?
A. You must reboot the Apstra server after changes are made to a predefined device profile before they will become active.
B. The changes you make to a predefined device profile will be discarded and overwritten when upgrading the Apstra server version.
C. The processor load on the Apstra server will be negatively impacted when changes are made to a predefined device profile.
D. Changing the predefined device profile will also affect deployed devices that use the same profile.
正解：B
解説: (Pass4Test メンバーにのみ表示されます)