最新なAvaya 6101.1問題集（70題）、真実試験の問題を全部にカバー！

質問 1：
Ethernet Routing Switch (ERS) 5500 portfolio shares a number of common hardware features.
Which feature is unique to the ERS 5530 and is not available on the other ERS 5500 switches?
A. User Interface push button
B. Universal Serial Bus (USB) port
C. Console serial port
D. Network management Ethernet port
正解：B

質問 2：
The goal of the Converged Campus architecture is to provide a highly reliable infrastructure with sub second failover preventing any interruption of traffic on the network.
HMD primary benefits of this design goal? (Choose two)
A. in the event of a failure, no loss of connectivity or application availability will be experienced by the end user
B. The architecture provides high performance Layer 3 switching, resiliency, security, and services.
C. The ability to provide hitless software upgrades for the core of the network.
D. This design goal provides numerous connectivity options including Asynchronous Transfer Mode (ATM), Packet over SONET (POS) and 10 gigabit Ethernet.
正解：A,C

質問 3：
One of the switches in the Ethernet Routing Switch (ERS) stacks files and is replaced.
The auto unit replacement (AUR) is enabled but the stack is not functioning properly.
What is the problem?
A. The switches in the stack are not identical
B. The switches in the stack are not running the same release of software
C. The stack has two switches with Force Stack disabled.
D. the stack power was left on during the switch replacement.
正解：D

質問 4：
A technician is preparing to update an Ethernet Routing Switch (ERS) 550D and needs to see the existing configuration. How is the information to be displayed?
A. Use the configuration parameter qualifier.
B. Use the show running-config command.
C. Use the verbose qualifier.
D. Use the show alt-modules command.
正解：B

質問 5：
A technician has implemented RSMLT edge design. After recovering from power outage some clients could not communicate. It has been stated that only one of the core RSMLT switches has recovered.
What should have been done to prevent the loss of communications?
A. Set the VLAN to copy RSMLT into from a similarity configured VLAN.
B. Clear the peer IP and MAC addresses.
C. Increase the hold up timer to 9999.
D. Turn off the hold down timer.
正解：D

質問 6：
Which two pairs of commands will configure spanning tree on the edge switch? (Choose two)
A. 5520-24T (config) # interface fastethernet 25-26 5520-24T (corrfig-if) # spanning-tree learning fast
B. 5520-24T (config) # interface fastethernet 1-20 5520-24T (config-if) # spanning-tree learning fast
C. 5520-24T (config) # interface fastethernet 1-20 5520-24T (config-if) # spanning tree learning disable
D. 5520-24T (config) # interface fastethernet 25-26 5520-24T (config-if) # spanning tree learning disable
正解：A,C
解説: (Pass4Test メンバーにのみ表示されます)

質問 7：
An Ethernet routing switch (ERS) 4550T-PWR has been deployed with a single AC power supply and is currently supporting 20 VoIP telephones with power over Ethernet (PoE). each with a power draw of 8 Watts when offhook.The network engineer has requested the addition of 5 Wireless Access points (WAPs) to the ERS 4550T-PWR.Each WAP supports PoE and requires 12 Watts of power.
What is the outcome of the addition of the WAPs to the ERS 455QT-PWR?
A. The 4550T-PWR will have sufficient power to support the 20 VoIP telephones and 5 WAP devices,
B. The addition of a second AC power supply will be required to provide sufficient power to the ERS -4550T-PWR to Support all of-the PoE devices.
C. the power requirement of the WAP exceeds the individual port maximum power rating of the ERS 4550T-PWR and will therefore require an external power source.
D. The addition of a Redundant Power Supply 15 will be required to provide sufficient power to ensure the VoIP phones and WAP function property.
正解：A