An NSX administrator is using ping to check connectivity between VM1 running on ESXi1 to VM2 running on ESXi2. The ping tests fails. The administrator knows the maximum transmission unit size on the physical switch is 1600.
Which command does the administrator use to check the VMware kernel ports for tunnel end point communication?
A. esxcli network diag ping -H <destination IP address>
B. esxcli network diag ping -I vmk0O -H <destination IP address>
C. vmkping ++netstack=geneve -d -s 1572 <destination IP address>
D. vmkping ++netstack=vxlan -d -s 1572 <destination IP address>
正解:C
解説: (Pass4Test メンバーにのみ表示されます)
質問 2:
Which of the following settings must be configured in an NSX environment before enabling stateful active-active SNAT?
A. A Punting Traffic Group for the NSX Edge uplinks
B. Tier-1 gateway in distributed only mode
C. Tier-1 gateway in active-standby mode
D. An Interface Group for the NSX Edge uplinks
正解:D
解説: (Pass4Test メンバーにのみ表示されます)
質問 3:
What needs to be configured on a Tler-0 Gateway lo make NSX Edge Services available to a VM on a VLAN-backed logical switch?
A. Downlink Interface
B. VLAN Uplink
C. Service Interface
D. Loopback Router Port
正解:C
解説: (Pass4Test メンバーにのみ表示されます)
質問 4:
Which CLI command shows syslog on NSX Manager?
A. get log-file auth.lag
B. show log manager follow
C. /var/log/syslog/syslog.log
D. get log-file syslog
正解:D
解説: (Pass4Test メンバーにのみ表示されます)
質問 5:
Which two CLI commands could be used to see if vmnic link status is down? (Choose two.)
A. esxcfg-vmknic -1
B. excli network nic list
C. esxcfg-nics -1
D. esxcfg-vmsvc/get.network
E. esxcli network vswitch dvs wmare list
正解:B,C
解説: (Pass4Test メンバーにのみ表示されます)
質問 6:
Which two choices are use cases for Distributed Intrusion Detection? (Choose two.)
A. Quarantine workloads based on vulnerabilities.
B. Use agentless antivirus with Guest Introspection.
C. Identify risk and reputation of accessed websites.
D. Identify security vulnerabilities in the workloads.
E. Gain Insight about micro-segmentation traffic flows.
正解:A,D
解説: (Pass4Test メンバーにのみ表示されます)
質問 7:
An NSX administrator is creating a Tier-1 Gateway configured In Active-Standby High Availability Mode. In the event of node failure, the failover policy should not allow the original tailed node to become the Active node upon recovery.
Which failover policy meets this requirement?
A. Enable Preemptive
B. Disable Preemptive
C. Preemptive
D. Non-Preemptive
正解:D
解説: (Pass4Test メンバーにのみ表示されます)
質問 8:
When deploying an NSX Edge Transport Node, what two valid IP address assignment options should be specified for the TEP IP addresses? (Choose two.)
A. Use BootP
B. Use an IP Pool
C. Use a Static IP List
D. Use a DHCP Server
E. Use RADIUS
正解:B,C
解説: (Pass4Test メンバーにのみ表示されます)
質問 9:
Which CLI command is used for packet capture on the ESXi Node?
A. set capture
B. pktcap-uw
C. debug
D. tcpdump
正解:B
解説: (Pass4Test メンバーにのみ表示されます)
Fukunaga -
すごく効果的な問題集です。2V0-41.23試験に合格するために勉強資料を探す人にこの問題集を進めます。私は合格しました!誠にありがとうございます。