How else can you tell the T1 has reached the cabinet if the DXU Operational LED is off??
A. The DXU Local LEDis flashing yellow
B. The dTRU Operational LED is fixed green
C. The associated Port LED(on the DXU)is fixed green
D. There is no other way
正解:C
質問 2:
To test an MO, it must be___.
A. In Remote mode
B. In local mode
C. Blocked
D. Broken
正解:C
質問 3:
Why can BTS power control be used to increase the capacity by tightening the frequency reuse in the network?
A. By saing MS battery life the number of mobiles (capacity)can be increased
B. Reduces number of mobiles with low C/I
C. Reduces number of mobiles with high C/I
D. Increase sensitivity of the mobile
正解:B
質問 4:
Assuming that an RBS 2106 cabinet is running at full capacity (i.e.,sixdTRUs), Which one of the following command lines must be used to block all timeslots for the third dTRU of Transceiver Group (TG) 25.
A. RXBLI:MO=RXOTS-25-1-0&&-7 & RXOTS-25-2-0&&-7;
B. RXBLI:MO=RXETS-25-4-0&&-7 & RXETS-25-5-0&&-7;
C. RXBLI:MO=RXOTS-25-4-0&&-7 & RXOTS-25-5-0&&-7;
D. RXBLE:MO=RXOTS-25-4-0&&-7 & RXOTS-25-5-0&&-7;
正解:C
質問 5:
In OMT, the System View shows:
A. BSC, PCM link, Alarm Inlets, RBS, OMT, IDB, and ETS
B. BTS, PCM link, Alarm Inlets, RBS, OMT, IDB, and ESI
C. BSC, PCM link, Alarm Inlets, RBS, OMT, ISP, and ESB
D. BSC, PCM link, Alarm Inlets, RBS, OMT, IDB, and ESB
正解:D
質問 6:
After ABTS rehome is complete,an"adjusement"job must be performed before the new configurationg is reflected in the CAN data base.
A. Flalse
B. Ture
正解:A
Abe -
おかげさまでED0-002試験に合格しました。ED0-002試験参考書が本当に助かりました。誠にありがとうございました。