The VSP9000 uses three distinct traffic management profiles, configured with the boot config flag fabric-profile command.
What is the default profile in the VSP9000?
A. Multicast Optimized
B. None, the profile must be set
C. Balanced Profile
D. Unicast Optimized
正解:C
解説: (Pass4Test メンバーにのみ表示されます)
質問 2:
Refer to the exhibit.
Simple Loop Prevention Protocol (SLPP) provides active protection against Layer 2 network loops on a per-VLAN basis. For the SLPP Tx process, the network administrator decides on which VLANs to enable SLPP. The hello packets are then replicated out all ports that are members of the SLPP-enabled VLAN.
Given the following information shown in the exhibit:
A = InterSwitch Trunk (IST)
B = Split MultiLink Trunk (SMLT)
# 1 VSP 9000
# 2 VSP 9000
# 3 ERS 4500
When setting up the SLPP Rx process, which configuration role is setup on VSP #1?
A. The VSP # 1 Rx process is enabled on all SMLT VLANs to monitor for the VSP # 2 SLPP packets.
B. The VSP #1 Rx process is enabled on all SMLT VLANs to monitor for the ERS #3 SLPP packets.
C. The VSP #1 Rx process is enabled on port 3/1 and the IST ports to monitor for the VSP #2 SLPP packets.
D. The VSP # 1 RX process is enabled on port 3/1 to monitor VSP # 1 and VSP #2 SLPP packets.
正解:C
質問 3:
Which statement describes a characteristic of Routed Split Multilink Trunking (RSMLT) configuration?
A. RSMLT is always used in conjunction with routing protocols and SMLT connections.
B. RSMLT uses priority values to distinguish between the primary and backup routers.
C. RSMLT is only configured on edge SMLT connections.
D. RSMLT routers are implemented with the VRF-Lite routers.
正解:A
質問 4:
After a chassis failure, you replace the Avaya Ethernet Routing Switch 8800/8600 with a new chassis that has a new base MAC address. To transfer the existing license to this new chassis you must have the new base MAC address.
Which CLI command will show you the base MAC address of your new chassis?
A. show sys base-mac
B. info sys base-mac
C. display sys info
D. show sys-info
正解:D
解説: (Pass4Test メンバーにのみ表示されます)
質問 5:
EAPOL and 802.1X are examples of which kind of security within the ERS8000?
A. Routing
B. Data Path
C. Management
D. Control Path
正解:A
解説: (Pass4Test メンバーにのみ表示されます)
質問 6:
While troubleshooting the VSP 9000 system, a technician notices that one port Link/Activity LED is blinking constantly or is nearly solid. This could be an indication of mis-configuration or high traffic volume.
Using the CLI, what is the logical first step in troubleshooting this situation?
A. Verify the port configuration parameters on both ends of the connection.
B. Verify the cable type and connectors on both ends of the connection.
C. Verify that there is not a broadcast storm by mirroring the traffic on that port.
D. Verify the port configuration parameters on the VSP 9000 system.
正解:A
質問 7:
The attempt to manage an Ethernet Routing Switch (ERS) 8000 using a VRRP address was unsuccessful.
What is causing this problem?
A. The virtual router identifier is 0.
B. The incorrect MAC offset is configured for the VRRP address.
C. A real IP address is required for management access not a VRRP address.
D. The datacenter interface is set as a critical IP interface.
正解:C
瑞原** -
Avayaのこの問題集だけで1度目で楽に6103の試験に合格できた。勉強時間は20時間ほど。