An administrator took Media Server, mediaA, offline for maintenance and set up a new Media Server, mediaB, with access to the previously backed up data. When restores are performed for data that was backed up by mediaA, the restores fail.
Which setting in the Host Properties must the administrator modify to allow successful restores?
A. Verify both Media Servers are set up in the Master Server Host Properties > Restore Failover section.
B. From the Master Server, run the bpimage command to change the name of the Media Server from mediaA to mediaB.
C. In the BAR GUI, change the "Server to use for backup and restores" setting to MediaB.
D. Verify both Media Servers are set up in the Media Server Host Properties > Restore Failover section.
正解:A
質問 2:
The Master Server catalog is being recovered to a new server. The administrator receives the message displayed below: Please insert the following media and run the volume configuration wizard or the vmupdate command to update the NetBackup database. Host - train1 MediaID - GBP847
Barcode - GBP847S1
In the Administration Console, barcode GBP847S1 is associated with media ID P847S1.
How should the administrator proceed?
A. delete the tape > set the barcode rule accordingly > re-inventory the library > run recovery
B. delete the tape > set the media ID generation rule accordingly > re-inventory the library > run recovery
C. use nbdelete to remove the media id > use vmadd to re-add the media id > re-inventory the library > perform recovery
D. use bplabel to change the media ID > re-inventory the library > perform recovery
正解:B
質問 3:
An organization needs to have backups span between different BasicDisk storage units. The "Allow backups to span disk" setting has been enabled in Host Properties.
Which additional requirement must an administrator meet to allow backups to span disks?
A. configure the Media Server as a Storage Server
B. create a disk pool with all the appropriate disk volumes
C. put the BasicDisk storage units in a storage unit group
D. enable the "Enable standalone drive extension" setting in host properties
正解:C
質問 4:
Which command can be used to recover the NBDB from the staging location?
A. bprestore
B. bprecover
C. nbdb_unload
D. nbdb_restore
正解:D
質問 5:
Which command should an administrator run to display all images written to both disk and tape for a particular client?
A. bplist
B. bpstulist
C. bpimmedia
D. bpimage
正解:C
Akimoto -
各項の注目点と基本的な考え方が分かりやすい内容だ。試験合格だけを狙うのであればもっとPass4Test簡易版のテキストでも十分だと思います。