Which of the following are supported interface types?
A. 10/100 Ethernet
B. Gigabit Ethernet, fiber
C. Gigabit Ethernet, copper
D. ATM
正解:A,B,C
質問 2:
One of the below will allow all of the NetCache appliance's present configuration settings to be viewed, which one is it?
A. showconfig *
B. showconfig ?
C. Showconfig.*
D. showconfig.?
正解:C
質問 3:
A customer is designing a FlexPod environment and is preparing for an ESXI host installation. High availability is a requirement for the FlexPod design. The ESXI servers will be built with new iSCSI boot LUNs.
Which two NetApp design components are required for this task? (Choose two.)
A. boot LUN UUID
B. iSCSI LIF IP addresses
C. boot LUN name
D. SVM target IQN
正解:A,B
質問 4:
One of the below ACLs will OK the requests from Engineering groups to www.netapp.com, which one could it be?
A. allow group "engineering" and server-domain www.netapp.com
B. allow groupname "engineering" and server-name matches "\.netapp\.com$"
C. allow groupname "engineering" and server-name www.netapp.com
D. allow group "engineering" and server-name www.netapp.com
正解:D
質問 5:
You are asked to design an application-focused data center using policy-based networking.
Which architecture is valid for this new design?
A. an architecture based on FabricPath configured between Nexus 7000 and Nexus 5000
B. an architecture based on Nexus 9000 to enable support for FCoE
C. a three-tier architecture based on Nexus 9000 to improve high availability
D. an architecture based on a spine and leaf topology that includes Nexus 9000
正解:A
質問 6:
One of these NetCache Utility features is capable of capturing packets that are currently in the process of arriving or leaving via the network interfaces, which one is it?
A. capture
B. tcpdump
C. pktt
D. snoop
正解:C
質問 7:
Which of the following commands allows the NetCache interface configuration to be viewed?
A. netstat -r
B. ifstat -a
C. sysconfig -a
D. ifconfig -a
正解:D
質問 8:
Which of the following does the NetCache not use when sending a packet beyond the local area network?
A. RIP routing updates to decide which router to send the packet to
B. ICMP redirects to decide which router to send the packet to
C. OSPF routing updates to decide which router to send the packet to
D. a static routing table to decide which router to send the packet to
正解:C