Click the Exhibit button.
Referring to the exhibit, what are two results of the cluster lead b command? (Choose two.)
A. The UCS will swap assigned IP addresses between FI-A and FI-B.
B. The UCS FI-B will become the cluster leader.
C. The UCS FI-A will reboot and FI-B will become the cluster leader.
D. The UCS will assign a cluster IP address to FI-
正解:B,D
質問 2:
Which three settings does a boot policy determine? (Choose three.)
A. the operating system to be installed
B. the configuration of the boot device
C. the service profile to be associated
D. the order in which boot devices are invoked
E. the location from which the server boots
正解:B,D,E
質問 3:
You are deploying a UCS and must connect to each blade through the KVM interface.
What are three system-side requirements to accomplish this task? (Choose three.)
A. You must use the correct version of Adobe Flash.
B. The blades must have an IP address.
C. You must have network connectivity.
D. You must use the correct version of Java.
E. You must connect using port 9443.
正解:B,C,D
質問 4:
Each UCS chassis in a Vblock System 300 is connected to two POUs.
What is the VCE recommended setting for the power policy?
A. n+1
B. switched power supply
C. non-redundant
D. grid
正解:D
質問 5:
Your client asks you to create three new UUID pool sets.
Where in the UIM/P would you complete this task?
A. service catalog
B. service manager
C. dashboard
D. administration
正解:D
質問 6:
Your client requires a UCS backup to be used to import system and logical configuration settings in a new UCS.
Which UCS backup type is used in this situation?
A. System Configuration
B. All Configuration
C. Full State
D. Logical Configuration
正解:B
質問 7:
During a Vblock System 340 deployment, you are asked to configure an ESXi server for testing. You install the server OS and setup the network configuration. You then create separate VLANs and port channels to the core switches. You are unable to ping the ESXi host on the blade. The network adapter shows a status of connected from the ESXi host on the correct vNIC.
Which two statements describe the reason for the problem? (Choose two.)
A. The disjointed Layer 2 network topology is not properly configured.
B. The UCS vNIC is not configured with the corresponding VLAN.
C. The ESXi host has no VLAN ID and VLAN tagging is not in use.
D. The ESXi host has a specified VLAN ID and VLAN tagging is not in use.
正解:B,D
質問 8:
Which service profile template is used to update a blades firmware?
A. Updating template
B. vNIC template
C. Power template
D. vHBA template
正解:A
質問 9:
Click the Exhibit button.
You are asked to cable the L1/L2 connections on a pair of UCS fabric interconnects. Referring to the exhibit, which cable is required for this configuration?
A. A
B. B
C. C
D. D
正解:C
山内** -
Pass4Testさんの問題集は解説が丁寧で理解が助かります。210-020本番試験に無事合格いたしました。